CLEANING THE DOOR GLASS
To prevent damaging or weakening the door glass panels avoid the use of the following:
Household detergents and bleaches
Impregnated pads unsuitable for non- stick saucepans
Brillo/Ajax pads or steel wool pads
Chemical oven pads or aerosols
Rust removers
Bath/Sink stain removers
Under no circumstances should the door assembly be detached from the product for cleaning.
TO REMOVE THE INNER GLASS
1.Fully open the oven door.
2.Firmly grasp the rear edge of the inner glass panel with both hands.
3.Push the glass panel towards you until it clears the hinge location points at the rear.
4.With one hand, carefully lift the glass panel to disengage it from the location points under the handle. (With your other hand, hold the outer door to ensure it does not spring shut on removing the inner panel).
5.Close the oven door.
If the door glass panel becomes chipped or has deep scratches the glass will be weakened and must be replaced to prevent the possibility of the panel shattering. Please contact your local Service Force Centre who will be pleased to advise further.
TO CLEAN THE INNER GLASS DOOR PANELS
Clean the inner door glass panels using a soft cloth and hot water to which a little washing up liquid has been added. If the inner panel is heavily soiled, Hob Brite may be used. Do not use abrasive cleaning materials on the door glass. Ensure that all parts are well rinsed and thoroughly dried before attempting to replace the glass.
Do not clean stainless steel outer panels (where fitted) with Hob Brite as damage to the finish will occur.
37