15. Noise coming | a) Whipper blade not properly aligned or | a) Check blade alignment, if needed replace blade and mixing | |
| from mixing | missing. | chamber. |
| chamber |
|
|
|
|
|
|
16. | Grinding noise | a) Hopper not properly engaged in back, or | a) Check the mating between the auger motor’s |
| coming from | Hopper not seated properly | gear and hopper’s coupling/nut. Check also pin in base. |
| unit |
| Pin must be dropped into hole in base. |
|
|
|
|
17. | Banging or | a) One or more Hoppers are empty or almost | a) Fill Hoppers with product. |
| clicking noise | empty. |
|
| coming from |
|
|
| hoppers |
|
|
TANK ASS’Y - ILL. F
1
2
3
1
4
5
6
7
8
9
10
11
12
13
14
15
16
17
ITEM | DESCRIPTION | P/N | QTY |
1 | SCREW, S.S., 1/4 - 20 x 5/8 | P465A | 3 |
2 | HEATER, 120V 1700W | G267A | 1 |
| HEATER, 240V, 3000W | G266A |
|
3 | GASKET, TANK HEATER | M502A | 1 |
4 | RUBBER GASKET, FOR SCREW (ITEM 1 P446A) | M533A | 2 |
5 | TUBE | K525A | 1 |
6 | TANK TOP | RY98A | 1 |
7 | WATER LEVEL PROBE [K402A + P410A] | K402Q | 1 |
8 | L573A | 1 | |
9 | GROMMET PLUG (.466 ID) F/TESTING TEMP. | M494A | 1 |
10 | THERMISTER PROBE | L639Q | 1 |
11 | HEATER DUCT HOUSING | RJ82A | 1 |
12 | SILICONE BUTT SPLICED GASKET [GB2MD] | M498A | 1 |
| SILICONE BUTT SPLICED GASKET (GB3MD) | M499A |
|
| SILICONE BUTT SPLICED GASKET [GB4MD] | M500A |
|
| SILICONE BUTT SPLICED GASKET (GB5MD) | M473A |
|
|
|
|
|
13 | TANK COVER BRACKETS | RI42A | 2 |
14 | TANK BODY | RI38A | 1 |
15 | GROMMET (.466 ID) | M461A | 9* |
16 | DISPENSE VALVE (DUMP) | L467A | 3* |
17 | TANK INSULATION MATERIAL | M183A | 1 |
18 | DRAIN HOSE (on a roll) | M483A | 1 |
19 | SILICONE DRAIN PLUG | M391A | 1 |
20 | COPPER PLATE- HEAT SINK FOR TRIAC | K770A | 1 |
| WINGED NUT for mounting plate to tank | P301A | 2 |
21 | TRIAC 35 AMP | L623A | 1 |
| SCREW for Triac | P182A | 2 |
|
|
|
|
* Quantity shown is for GB3M5.5 IT. Quantities very for each unit.
18
19 20 21
23