Sanyo MBR-304DR Disposal of Unit, Replacement of glow starter, Cleaning of condenser filter

Page 22

ROUTINE MAINTENANCE

Replacement of glow starter

A glow starter is located upper right side of the cabinet..

1. Disconnect the power supply plug.

2. Remove the glow starter and replace with a new

one.

Glow starter

3.Replace the water-proof rubber.

Cleaning of condenser filter

This unit is provided with the condenser filter at the bottom of the cabinet. Clean the filter once a month even since a clogged filter may cause shorter compressor life as well as the poor cooling.

Clean the filter by the procedure below.

1. Turn off the power switch.

2.Take out the condenser filter as shown in the figure.

3. Wash the filter with water and dry it naturally.

4. Replace the filter.

DISPOSAL OF UNIT

WARNING

If the unit is to be stored unused in an unsupervised area for an extended period ensure that children

do not have access and doors cannot be closed completely.

The disposal of the unit should be accomplished by appropriate personnel. Always remove doors to prevent accidents such as suffocation.

廢電池

請回收

This product has an electric battery.

Please recycle it for effective utilization of resources and protection of our environment. Thank you for your cooperation.

Label indication is obliged to comply with Taiwanese battery regulation.

21

Image 22
Contents MBR-304DR MBR-304GR MBR-304D MBR-304G Contents Precautions for Safe Operation Symbol showsPrecautions for Safe Operation Prevent electric shock or injury Damage Page Environmental Conditions Refrigerator Components Refrigerator Components Control panel and keypad Installation Installation siteInstallation Preparation of monitor bottle Before Commencing OperationLoosen Remote alarm terminal Operation after power failure START-UP of UnitAir-intake vent Operating InstructionsStoring of items Air-exhaust ventCycle defrost Temperature displayDefrost cycles Forced defrostCalibration of temperature sensor Alarms and safety functions Alarms & Safety FunctionsAlarm test procedure Cleaning of cabinet Routine MaintenanceReplacement of fluorescent lamp Cleaning of condenser filter Replacement of glow starterDisposal of Unit Alarm device is activated TroubleshootingIf nothing operates even when switched on When the unit does not get cold enoughSpecifications PerformanceSafety check sheet CEM