Extron electronic TP T 15HD A, TP T BNC DA4, TP T 468 Input cabling, Computer video and PC audio

Installation and Operation, cont’d

Ground the transmitter using any of the following methods:

•Connect a local 15 V power supply to the transmitter.

•Use STP rather than UTP cable and connectors.

•TP T 15 HD A and TP T 15HD AV — Use a 3.5 mm captive screw connector to connect a ground wire between the power return pin (figure 2-13) and a grounding point near the transmitter, such as a grounded power outlet or an equipment rack.

•TP T 468 only — Connect a ground wire between the power return pin (figure 2-13) of the 3.5 mm, 2-pole direct-insertion captive screw connector on the rear of the transmitter and a grounding point near the transmitter.

2 1 4 3

ID PIN 4	ID PIN 11
COMPUTER	BUFFERED	H-SHIFT
AUDIO
INPUT	LOCAL MONITOR

TP T 15HD A

11	9	5
		DDSP SPARE

POWER

15V .5A DC

OUTPUT

Figure 2-14 — Installation features, TP T 15HD A

TP T 15HD A and

TP T 15HD AV

N/C

Return

TP T 468

2 1 4 3 6 7

ID PIN 4	ID PIN 11	PC	VIDEO	AUDIO
COMPUTER	BUFFERED
AUDIO		H-SHIFT
				L	R

INPUT LOCAL MONITOR

TP T 15HD AV

Grounding Point near Transmitter

Figure 2-13 — Grounding the transmitter

Input cabling

Computer video and PC audio

The TP T 15HD A (figure 2-14), the TP T 15HD AV (figure 2-15), and the TP T 468 (figure 2-16) all accept and transmit computer video and PC audio. These transmitters can also accommodate component video, S-video, or composite video if input on the R, G, and B pins of the 15HD connector using an Extron SYM BNCF/0.5 6" (15 cm) cable,

part #26-531-01.

11	10	9	5
			DDSP SPARE

POWER
15V .5A DC
AV	COMPUTER
	OUTPUTS

Figure 2-15 — Installation features, TP T 15HD AV

2-20 Extron TP Transmitters • Installation and Operation Extron TP Transmitters • Installation and Operation 2-21