TIMER
You can set and use the Timer function independently, or while a cooking program is in progress. The Timer will be displayed on the lower line of the display. Timer can be set from 0 to 99 minutes 99 seconds. Example:To set timer for 3 minutes:
Step | Procedure | Keypad |
1 | Press Timer. | _Timer _ |
2 | Press3, 0 and 0 to set 3 minutes. | _@@ |
3 | The timer startscounting and oven will | TAR |
| beep for 7 seconds when time is up. |
|
Note: • To clear a Timer setting, press Stop/Clear.If you are using both Timer and cooking, press Timer. Timer on the lower line of the display flashes for 5 seconds. Press STOP/CLEAR while Timer on the lower line of display flashes. The Timer will stop but the oven continues cooking to the end.
•To stop beeps of Timer, touch Timer.
•Timer will not beep if the oven beeps atthe same time to indicate another oven operation (the end of a cooking, for example).
•If you do not enter a time for 10 seconds after step 1, the setting is cleared with a beep.
•If cooking completes while you are setting the Timer, all settings are cleared. Restart from step 1.
•If no key is touched for 5 seconds after the last key entry at step 2 above, the timer automatically starts.
TIMED COOKING AND POWER LEVEL
This basic microwave cooking method allows you to cook food for a desired time. The oven can be programmed up to 99 minutes 99 seconds of cooking. In addition to the P100 (maximum) power level, you can select different microwave power from 10 levels, P 0 to Pg0
You can program the oven for up to 3 stages of cooking in sequence. Each stage can be programmed with a different time setting and power level. To program
Steps
programmed. After the time and power levels have been entered for all stages, press START. The oven will cook in accordance with the time and power sequencesthat were entered.
Delay Start Cooking:
You can delay the time that you would like the cooking to start. Cooking can be delayed up to 99 minutes and 99 seconds, To delay cooking, follow procedure for multistage cooking, but for stage1 use power level P 0.
14