Bunn DUAL068000 manual SET Preinfusion, Batches DONE?

Page 23

PROGRAMMING THE BREWER (cont.)

SET PREINFUSION:

This function sets the brewer to turn the sprayhead flow on for a preset time (1st ON TIME) followed by a preset spray pause (OFF TIMES) and then turn the spray on continuously until the brew volume is completed.

This is a special case of pulse brew. It is not pos- sible to set a batch size to have both pulse brew and preinfusion. One or the other (or neither) must be chosen. However, it is possible to set one batch size to pulse brew and the other two to preinfusion or vice versa.

NOTE: The procedure to enter the PULSE BREW function must be performed prior to following the steps listed below.

1.Press and release YES. The display should now read EASY PULSE SETUP.

2.Press and release NO. The display will read ENTER

TIMES?

3.Press YES to proceed. The display should now read 1st ON TIME X:XX.

4.Using (-)and (+) set the amount of time the flow of water into the funnel will be on.

5.When finished, press DONE. The display will now read OFF TIMES: X:XX.

6.Using (-)and (+) set the amount of time the flow of water into the funnel will be off.

7.When finished, press DONE. The display will now read LAST ON: PreI

8.If the display shows a time use (-)and (+) to set it to read PreI. (PreI is an abreviation for preinfu- sion)

9.When finished, press DONE. The display will show the two settings and PreI just entered for that batch size. After a 5 second delay, the display will read

3 BATCHES DONE?

10.If other batch sizes need to be modified, press

NO.

12.Press a different batch size pad and repeat steps 3 through 7. Repeat until all the desired batch sizes are set.

13.When finished press YES in 3 BATCHES DONE?. The display will then read DRIP TIME.

14.Press and release the ON/OFF switch (either on DUAL brewers) located on the front switch panel to exit the SET PULSE BREW function and return to the MAIN SCREEN.

NOTE: Pressing the upper right hidden switch before reaching the final setting screen exits the setup and retains the old values.

SET PULSE BREW?

 

NO

YES

 

EASY PULSE SETUP

 

NO

YES

EXIT TO

 

 

 

 

NEXT FUNCTION

 

 

SCREEN

ENTER TIMES?

 

NO

YES

 

1st ON TIME X:XX (-) DONE (+)

OFF TIMES: X:XX (-) DONE (+)

LAST ON: Prel (-) DONE (+)

1st OFF LAST XX.X XX.X Prel

5 SEC. DELAY

3 BATCHES DONE?

NO YES

EXIT TO

NEXT FUNCTION

SCREEN

Page 23

41342 080108

 

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Dualtf DBC BUNN-O-MATIC Commercial Product Warranty Introduction Glossary Programming Programming SwitchesBrew Lockout Programming Lockout Switch mounted on main control boardScreen Outputs Main ScreenDRIP-OUT Times Program Functions LevelRecipes Continue to LevelProgramming the Brewer Program Flow DiagramProgram Flow Diagram Procedure for modifying units of measure Units Setting Units of MeasureRecipe Procedure for Setting the RecipeSET NEW Recipe Sizes DONE? SET NEW RecipeProcedure to program the coffee name Review RECIPES? No YES WAS the Last Recipe Review RECIPES/MODIFY RECIPES/SET UP no Name Coffee FavorsProcedure for reviewing recipes Review RecipesReview RECIPES? Noyes Brew OZ Setting or Adjusting Brew VOL- UmesBypass Modifying pulse brew SET Pulse BrewNO-NAME Left Modify Show Next SET Pulse BrewSET Pulse Brew Easy Pulse Setup DONE? SET Pulse Brew Enter TimesTIMES? Batches DONE? SET PreinfusionDrip Time now displayed on non funnel lock units as well Procedure to modify drip timesSetup Complete Assign Recipes Procedure to assign recipesCopy Settings no Name Coffee Settings only Procedure to copy settingsSET Temp Enable ADS?YOU SURE? Are YOU SURE?Refill Range 20 to Procedure to set ready temperatureSET Temp SET ReadySpray OZ/M Dual Brewers Procedure to adjust the flow rate settingSpray OZ/M Single Brewers Bypass OZ/M Dual Brewers Bypass OZ/M Single BrewersCalibrate Flow ? Procedures to calibrate the sprayhead flow rateCalibrate Flow Brate Bypass .. Press Brew to Start Calibrate Flow Procedures to calibrate the bypass flow rateBrew Counters Procedures to view/reset the brew countersLeft Brew Valve Service ToolsFunnel Detect Nothing Pressed Service ToolsProcedure to test switches Procedures to test coil frequencyYES FREQUENCY? Main Screen Factory DefaultsProcedure to set factory defaults
Related manuals
Manual 10 pages 56.74 Kb Manual 9 pages 50.59 Kb

DUAL068000 specifications

The Bunn DUAL068000 is an advanced commercial coffee maker designed for high-volume environments where speed, efficiency, and quality are paramount. This dual-brew coffee maker seamlessly combines performance with innovative technologies to meet the demands of cafes, restaurants, and convenience stores.

One of the standout features of the DUAL068000 is its dual brewing capabilities. It allows for the simultaneous brewing of two different types of coffee. This flexibility is particularly valuable in busy settings where diverse customer preferences must be accommodated. Operators can brew a full pot of drip coffee while simultaneously preparing a specialty coffee drink, optimizing workflow and minimizing wait times.

Equipped with a powerful heating element, this coffee maker can brew a full 12-cup pot in under four minutes. This rapid brewing time ensures that fresh coffee is always available, keeping customers satisfied and coming back for more. The DUAL068000 utilizes a unique hot water faucet that provides water on demand, making it easy to prepare tea or other hot beverages without disruption to the brewing process.

The DUAL068000 incorporates Bunn’s patented brewing technology, which includes temperature control and precision brewing features. The machine maintains consistency in water temperature throughout the brewing cycle, ensuring optimal extraction and rich flavor profiles in every cup. Its adjustable brew time allows operators to customize the strength of their coffee according to specific needs.

In terms of durability, the Bunn DUAL068000 is built to withstand the rigors of commercial use. Made from high-quality stainless steel, it offers a robust design that is both easy to clean and resistant to wear and tear over time. The easy-to-navigate control panel provides intuitive operation, allowing staff to quickly adjust settings without extensive training.

Another key characteristic of this machine is its energy-efficient design. Bunn has incorporated features that minimize energy consumption while maximizing output, making the DUAL068000 an eco-friendly choice for coffee businesses seeking to reduce their carbon footprint.

Overall, the Bunn DUAL068000 coffee maker combines reliability, efficiency, and flexibility, making it an ideal choice for any establishment looking to serve exceptional coffee quickly and efficiently. Its advanced technology and robust build quality position it as a leader in the commercial coffee maker market.
Top Page Image Contents