Cleaning
1.Hand wash all parts of the oven and glazer with warm soapy water.
2.Do not use caustic cleaners on oven parts.
3.You may use an approved oven cleaner on the stainless steel finger cover only. (see step 27 of Disassembly)
4.Do not use oven cleaner on any other part of the oven or glazer!
5.Do not hose/spray down any part of this machine.
6. Glaze pump body and parts.
2.Install the drive gear impeller. Line up the flat on the shaft with the flat in the impeller.
3. Install the lay gear impeller.
CAUTION
Failure to properly clean or lubricate glaze pump may cause damage to the pump gear impellors.
Assembly
NOTE
Lubricate the pump body, shaft “o” ring and gear impellors with food grade mineral oil.
1. Install the glaze pump body.
4.Install the “O” ring into the glaze pump cover. Make sure it stays in place and you do not pinch it between the pump and cover. The “O” ring may need to be stretched before installing.
Belshaw Bros., Inc. • 1750 22nd Ave. S. • Seattle, WA 98144 • Phone
16 |
| Thermoglaze 50 |