Extron electronic MP 101 user manual MLP 101 AAP

b Phantom power switch — Provides switchable 48 volt phantom power for condenser microphones.

Audio output (line level)

c Line Output — A 3-pin, captive screw connector outputs to audio mixers, amps switchers, or other non-microphone audio equipment.

3/16"

(5 mm) MAX

Captive Screw

Connector stripping

Tip

Ring

Sleeve

CAUTION

For unbalanced audio, connect the sleeve(s) to the ground. DO NOT connect the sleeve(s) to the negative (-) contact.

Tip

NO Ground Here

Sleeve

Balanced Output	Unbalanced Output
	(high impedance)

d Low Cut filter switch — Provides low cut filtering to remove wind and “table rumble” noise.

Remote connection

e Remote — An optional 3-pin, captive screw connector allows a wall mounted audio controller or MediaLink product to remotely control volume and mute levels for the MP 101 unit. See “Remote Control”, later in this chapter, for more information.

Front Panel Features

3

MIC

IN

ACTIVE

MUTE

MLP 101 AAP

1 2 4

a XLR mic input — Use an XLR connector or a standard microphone connection. See the following illustration and table for connector pin out information.

MP 101 Series • MP 101 AAP 3-3