Extron electronic user manual MP 101 Series Architectural Installation

Page 35

If the MP 101 will be installed without a wall box (using mud rings or fastening it directly to the wall or furniture), measure and mark the surface for the cutout area indicated in the template.

3.Cut out the material from the marked area.

4.Check the opening size by inserting the wall box (if used) or the MP 101 (if no box is used) into the opening. The box and preamplifier should fit easily into the opening. Enlarge or smooth the edges of the opening if needed.

5.Feed cables through the wall box punch-out holes, and secure them with cable clamps to provide strain relief.

6.Exposed cable shields (braids or foil) are potential sources of short circuits. Trim back and/or insulate shields with heat shrink.

Metal Wall Box

Screw

Cable Clamp

Braided Shield

Install Cable

Foil Shield

WTo prevent short circuits, cut back the outer foil shield to the point where the cable exits the cable clamp. Both braided and foil shields should be connected to an equipment ground at the other end of the cable, as shown above.

7.Insert the wall box into the opening, and attach it to the wall, stud, or furniture.

MP 101 Series • Architectural Installation

5-3

Image 35
Contents Microphone to Line Preamplifiers MP 101 SeriesPrecautions FCC Class a Notice Table of Contents Chapter Five Architectural Installation Introduction OneMP 101 Series Introduction FeaturesIntroduction About this Manual About the MP 101, MP 101 AAP, MP 101 DMP 101 Series Introduction Two MP 101 Series MP Rear Panel FeaturesPower input MP 101 Series MP 101 Mic input microphone levelAudio output line level Front Panel FeaturesMP 101, cont’d Remote connectionTabletop use Mounting the MPRack installation Back of the rack installation Furniture mounting Adjusting the MP 10 MP 101 Series MP MP 101, cont’d Remote ControlRemote connector wiring Remote control optionsMP 101 AAP ThreeMP 101 Series MP 101 AAP MP 101 AAPMLP 101 AAP MP 101 AAP, cont’d Adjusting the MP 101 AAPMounting the MP 101 AAP Remote Remote control options MP 101 D FourMP 101 Series MP 101 D MP 101 D About the MP 101 DAudio output line level MP 101 D, cont’d Front Panel Features Mounting the MP 101 D Adjusting the MP 101 DExtron MP 101 D MP 101 D, cont’dRemote Control Five Architectural InstallationMP 101 Series Architectural Installation Architectural Installation Installation InstructionsPreparing the Site and Installing the Wall Box MP 101 Series Architectural Installation Architectural Installation, cont’d AAppendix a Specifications, Part Numbers, and AccessoriesAudio output Specifications, Part Numbers, and AccessoriesAudio Audio inputGeneral UL, CUL Included parts Part number Included PartsAccessories Part number Optional AccessoriesAppendixBB Dimensions and Template for the MP 101 DMP 101 Series Dimensions and Template for the MP 101 D Dimensions and TemplateTemplate MP 101 DUSA, Canada, South America Japan Central America Extron’s WarrantyExtron Electronics. All rights reserved