2 1
3
Female
Adjusting the MP 101 D
Adjustment options for the MP 101 D are located on its rear panel (see “Rear Panel Features” in this chapter for details). Therefore, you must perform these adjustments before mounting into a wall.
To adjust the MP 101 D, do the following:
1.If using a condenser microphone, set the Phantom power switch to the “on” position.
If using a dynamic microphone, set the Phantom power switch to the “off” position.
2.When using the microphone for voice audio, flip the Low Cut switch to “on” to reduce wind and “table rumble” noise.
When using the microphone for music audio, set the Low Cut switch to “off” to preserve the optimum sound quality.
3.Set the Mic Gain potentiometer by saying a few words into the microphone and adjusting for the maximum sound level that is free of distortion.
NIf there is a remote control connection, unplug it while adjusting the Mic Gain potentiometer. Replace the remote control when finished.
If there is minimal distortion, but greater volume is required, turn the Mic Gain potentiometer clockwise (towards the 75 dB mark) to increase the volume, but not past the point where distortion occurs.
Mounting the MP 101 D
The MP 101 D provides the same features as the other
MP 101 models in a convenient, Decora style wallplate.