Extron electronic MP 101 user manual Audio output line level

Page 28

NDo not tin the stripped power supply leads before installing the captive screw connector. Tinned wires are not as secure in the captive screw connectors and could pull out.

WThe two power cord wires must be kept separate while the power supply is plugged in. Remove power before continuing.

Audio output (line level)

b Phantom power switch — Provides switchable 48 volt phantom power for condenser microphones.

c Line Output — A 3-pin, captive screw connector outputs to audio mixers, amps switchers, or other non-microphone audio equipment.

3/16"

(5 mm) MAX

Captive Screw

Connector stripping

Tip

Ring

Sleeve

CAUTION

For unbalanced audio, connect the sleeve(s) to the ground. DO NOT connect the sleeve(s) to the negative (-) contact.

Tip

NO Ground Here

Sleeve

d Low Cut filter switch — Provides low cut filtering to remove wind and “table rumble” noise.

Remote connection

e Remote — An optional 3-pin, captive screw connector allows a wall mounted audio controller or MediaLink product to remotely control volume and mute levels for the MP 101 unit. See “Remote Control”, later in this chapter, for more information.

MP 101 Series • MP 101 D 4-3

Image 28
Contents MP 101 Series Microphone to Line PreamplifiersPrecautions FCC Class a Notice Table of Contents Chapter Five Architectural Installation One IntroductionFeatures Introduction About this ManualAbout the MP 101, MP 101 AAP, MP 101 D MP 101 Series IntroductionMP 101 Series Introduction Two Power input Rear Panel FeaturesMP 101 Series MP Mic input microphone level MP 101 Series MP 101Front Panel Features MP 101, cont’dRemote connection Audio output line levelMounting the MP Tabletop useRack installation Back of the rack installation Furniture mounting Adjusting the MP MP 101, cont’d Remote Control Remote connector wiringRemote control options 10 MP 101 Series MPThree MP 101 AAPMP 101 AAP MP 101 Series MP 101 AAPMLP 101 AAP Adjusting the MP 101 AAP MP 101 AAP, cont’dMounting the MP 101 AAP Remote Remote control options Four MP 101 DMP 101 D About the MP 101 D MP 101 Series MP 101 DAudio output line level MP 101 D, cont’d Front Panel Features Adjusting the MP 101 D Mounting the MP 101 DMP 101 D, cont’d Extron MP 101 DRemote Control Architectural Installation FivePreparing the Site and Installing the Wall Box Architectural Installation Installation InstructionsMP 101 Series Architectural Installation MP 101 Series Architectural Installation Architectural Installation, cont’d Specifications, Part Numbers, and Accessories AAppendix aSpecifications, Part Numbers, and Accessories AudioAudio input Audio outputGeneral UL, CUL Included Parts Included parts Part numberOptional Accessories Accessories Part numberDimensions and Template for the MP 101 D AppendixBBDimensions and Template MP 101 Series Dimensions and Template for the MP 101 DMP 101 D TemplateExtron’s Warranty USA, Canada, South America Japan Central AmericaExtron Electronics. All rights reserved