MP 101 AAP, cont’d
4. Repeat steps 1 through 3 to mount any other AAPs. Cover any openings in the faceplate with blank plates (provided).
5.If it was not done previously, adjust the MP 101 AAP from its rear panel. See the previous section, “Adjusting the MP 101 AAP” for detailed instructions.
6.Pretest the MP 101 AAP before final mounting of the faceplate.
7.Perform the final mount by attaching the cabled device faceplate or AAP wallplate into a wall or piece of furniture. For detailed installation information, refer to the installation guide shipped with the faceplate.
Remote Control
The wiring and control options described below pertain to all models in the MP 101 series.
Remote connector wiring
Pin 1 is 10 VDC reference voltage. Pin 2 is volume control DC voltage; range is 0 to 10 V, where 0 V is mute and 10 V provides maximum volume. Pin 3 is ground.
NAll nominal levels are at ±10%.
MAX
10K
MIN
REMOTE
1 | 2 | 3 |
10V
VOL/MUTE
1
2K
2
MUTE
3
GND