A.Checks Before Installation

II. Installation and Operating Instructions

WARNING

1.This icemaker must be installed in accordance with applicable national, state, and local regulations.

2.CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are securely in place after installation. Make sure that none have fallen into the storage bin.

•Visually inspect the exterior of the shipping container and immediately report any damage to the carrier. Upon opening the container, any concealed damage should also be immediately reported to the carrier.

•Remove the shipping carton, tape, and packing material. If any are left in the icemaker, it will not work properly.

•Remove the panels to prevent damage when installing the icemaker. See "II.B. How to Remove Panels."

•Remove the package containing the accessories.

•Remove the protective plastic film from the panels. If the icemaker is exposed to the sun or to heat, remove the film after the icemaker cools.

•Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the fan blade (if applicable) turns freely.

•Check that the compressor is snug on all mounting pads.

•See the nameplate on the rear panel, and check that your voltage supplied corresponds with the voltage specified on the nameplate.

•This icemaker can be installed on a countertop or on an optional stand. If using an optional stand, Hoshizaki Stand SD-700 or SD-750 is recommended.