B. Maintenance
IMPORTANT
1.This icemaker must be maintained individually, referring to the instruction manual and labels provided with the icemaker.
2.To have the optimum unit performance, the following parts need periodic inspection and maintenance:
Extruding Head and Upper Bearing Housing and Lower Bearing Mechanical Seal
Auger
Evaporator Cylinder Gear Motor
These parts should be inspected at least once a year or every 10,000 hours of operation. Their service life, however, depends on water quality and environment. More frequent inspection and maintenance are recommended in bad or severe water conditions.
Replacement of the following consumable parts is recommended if wear exceeds factory recommendations:
Upper Bearing
Lower Bearing
Mechanical Seal
Consult with your local distributor about inspection and maintenance service. To obtain the name and phone number of your local distributor, call Hoshizaki Technical Support at
1) Stainless Steel Exterior
To prevent corrosion, wipe the exterior occasionally with a clean and soft cloth. Use a damp cloth containing a neutral cleaner to wipe off oil or dirt build up.
2)Storage Bin and Scoop
•Wash your hands before removing ice. Use the plastic scoop provided (bin accessory).
•The storage bin is for ice use only. Do not store anything else in the bin.
•Keep the scoop clean. Clean using a neutral cleaner and rinse thoroughly.
•Clean the bin liner using a neutral cleaner. Rinse thoroughly after cleaning.
3)Air Filter
A plastic mesh air filter removes dirt or dust from the air, and keeps the condenser from getting clogged. As the filter gets clogged, the icemaker’s performance will be reduced. Check the filter at least twice a month. When clogged, use warm water and a neutral cleaner to wash the filter.
4) Condenser
Check the condenser once a year, and clean if required by using a brush or vacuum cleaner. More frequent cleaning may be required depending on the location of the icemaker.
49