Operator's Safety Precautions
1.Read and understand the operating instructions in this manual thoroughly.
2.Note all warning labels on the freezer. If any warning labels are missing or damaged replace them immediately.
3.Do not wear loose fitting garments or jewelry which could cause a serious accident.
4.Stay alert at all times during operation.
5.Keep operating area clean.
6.Do not operate freezer if any excessive noise or vibration occurs. Contact your authorized service agent.
Installation
Shipment & Transit
The freezer has been operated and tested at the factory. Upon arrival the complete freezer must be thoroughly checked for any damage which may have occurred in transit.
Note: A Tip (N) Tell warning device is placed on each shipping carton at the factory. If the arrow tip is blue, the carton has been tipped in transit.
Removal from Carton and Pallet
1.Remove staples or cut cardboard box around the stapled area.
2.Pull the cardboard box up off machine.
3.Remove the Styrofoam packing and the plastic bag.
4. Remove both side panels with screwdriver. | Figure A |
5.Use a wratchet with a 3 inch extension and a 7/16 socket to remove the shipping bolts (connecting the machine to the pallet) located on both sides of the frame bottom plate.
6.Supporting all four sides, lift machine up and place in appropriate area.
THE CARRIER IS RESPONSIBLE FOR ALL DAMAGE IN TRANSIT WHETHER VISIBLE OR CONCEALED. DO NOT PAY THE FREIGHT BILL until the freezer has been checked for damage. Have the carrier note any visible dam- age on the freight bill. If concealed damage and/or shortage is found later, advise the carrier within 10 days and request inspection. The customer must place any claim for damage and/or shortage with the carrier. Grindmaster Corporation cannot make any claims against the carrier.
!CAUTION: IF EQUIPPED WITH SPINNER DO NOT LIFT UNIT BY SPINNER SHAFT TO AVOID SERIOUS DAMAGE TO SPINNER.
Crathco® 5512 Manual | Page 3 |
|
|