Manitowoc Ice QM45 Series service manual Typical Water Supply Drain Installation

Page 15

Section 2

 

 

 

Installation Instructions

WATER SUPPLY AND DRAIN LINE SIZING/CONNECTIONS

 

 

 

 

 

 

 

 

CAUTION

 

 

 

 

Plumbing must conform to state and local codes.

 

 

 

 

 

 

Ice Machine

 

Location

Water

Water

Tubing Size Up to Ice

Temperature

Pressure

Fitting

Machine Fitting

 

Ice Making

33°F (0.6°C) Min.

20 psi (137.9 kPA) Min.

3/8” Female Pipe

3/8” (9.5 mm)

minimum inside

Water Inlet

90°F (32.2°C) Max.

80 psi (551.5 kPA) Max.

Thread

diameter

 

 

 

 

 

Bin Drain

---

---

 

3/4” (19.1 mm)

N/A

 

Vinyl Tubing

 

 

 

 

 

Typical Water Supply Drain Installation

ICE MAKING WATER

INLET TUBING

3/8″ MIN. I.D. (.95CM)

WATER SHUTOFF

VALVE

SV1735

ICE MAKING

WATER/BIN DRAIN

5/8″ I.D. (1.59CM)

2-7

Page 14 Page 16
Image 15
Page 14 Page 16
Contents QM45 Series Ice Machines Installation, Use, CareSafety Notices Procedural NoticesThis manual covers the following model numbers Table of Contents Maintenance Before Calling for ServiceChecklist Safety Limit Feature Safety Limits Model Numbers AccessoriesSection General Information Section General InformationGeneral Information Section Model/Serial Number LocationModel/Serial Number Location Commercial Warranty Coverage Owner Warranty Registration CardWHO is Covered by this Limited WARRANTY? Residential Warranty CoverageSection Section Installation InstructionsInstallation Instructions Ice Machine DimensionsInstallation Instructions Section Location of Ice MachineIce Machine Heat of Rejection Leveling the Ice Machine Leveling LEGChecking Ice Machine LevelLeveling Leg and Foot This page Intentionally Left Blank QM-45 ICE Machine FUSE/CIRCUIT Breaker Electrical ServiceFor United Kingdom Only VoltageDrain Connections Water Service/DrainsWater Supply Water Inlet LinesWater Supply and Drain Line SIZING/CONNECTIONS Typical Water Supply Drain InstallationInstallation Checklist Before Starting the Ice MachinePersonal Injury Potential Section Ice Machine Operation Ice Machine OperationComponent Identification Ice Machine Operation Section Ice Making Sequence of OperationInitial START-UP or START-UP After Automatic SHUT-OFF QM45 SELF-CONTAINED AIR Cooled Models Water Level Check Operational ChecksSiphon System Siphon System CheckIce Thickness Check ICE Thickness CheckThis page Intentionally Left Blank Cleaning and Sanitizing Procedure Section MaintenanceSection Maintenance Interior Cleaning and SanitizingMaintenance Section Water Distribution Tube Removal DisassemblyWater Distribution Tube Disassembly Remove the Water Distribution TubeInstallation Remove the Water TroughRemove the Ice Damper Remove the Bin Door Model Air-Cooled Condenser Exterior CleaningCleaning the Condenser ICE Machine InspectionSELF-CONTAINED AIR-COOLED ICE Machines Removal from Service WinterizationSection Before Calling for Service Before Calling for ServiceChecklist Safety Limit Feature Before Calling for Service SectionSafety Limit Notes Safety LimitsSafety Limit Stand-By Mode Determining Which Safety Limit Stopped The Ice MachineSafety Limit #2 Safety Limit #1Page Manitowoc ICE, INC
Top Page Image Contents