Manitowoc Ice QM45 Series Remove the Water Distribution Tube, Water Distribution Tube Removal

Page 25

Section 4		Maintenance

D. Remove the Water Distribution Tube

3 2

1. LIFT UP

2. SLIDE BACK1

3. SLIDE TO RIGHT

THUMBSCREW

DISTRIBUTION

TUBE

LOCATING PIN

SV127

THUMBSCREW

Water Distribution Tube Removal

•Loosen the two thumbscrews, which secure the distribution tube.

•Lift the right side of the distribution tube up off the locating pin, then slide it back and to the right.

CAUTION

Do not force this removal. Be sure the locating pin is clear of

the hole before sliding the distribution tube out.

E. Remove the Float Valve

•Turn the splash shield counterclockwise one or two turns.

FLOAT VALVE

BRACKET

COMPRESSION

FITTING

SHUT-OFF

VALVE

CAP AND FILTER

SCREEN

SPLASH SHIELD

FLOAT

Disassembly

• Twist both of the inner tube ends until the tabs

Float Valve Removal

SV1695-2

line up with the keyways.

• Pull the inner tube ends outward.

INNER

TUBE

INNER
TUBE	TAB

KEYWAY

Water Distribution Tube Disassembly

SV1211

•Pull the float valve forward and off the mounting bracket.

•Disconnect the water inlet tube from the float valve at the compression fitting.

•Remove the cap and filter screen for cleaning.

4-3

Image 25

Contents QM45 Series Ice Machines Installation, Use, CareProcedural Notices Safety NoticesThis manual covers the following model numbers Table of Contents Before Calling for Service MaintenanceChecklist Safety Limit Feature Safety Limits Section General Information AccessoriesSection General Information Model NumbersModel/Serial Number Location General Information SectionModel/Serial Number Location Commercial Warranty Coverage Owner Warranty Registration CardWHO is Covered by this Limited WARRANTY? Residential Warranty CoverageInstallation Instructions Section Installation InstructionsIce Machine Dimensions SectionLocation of Ice Machine Installation Instructions SectionIce Machine Heat of Rejection Leveling LEGChecking Ice Machine Level Leveling the Ice MachineLeveling Leg and Foot This page Intentionally Left Blank For United Kingdom Only Electrical ServiceVoltage QM-45 ICE Machine FUSE/CIRCUIT BreakerWater Supply Water Service/DrainsWater Inlet Lines Drain ConnectionsWater Supply and Drain Line SIZING/CONNECTIONS Typical Water Supply Drain InstallationBefore Starting the Ice Machine Installation ChecklistPersonal Injury Potential Ice Machine Operation Section Ice Machine OperationComponent Identification Ice Making Sequence of Operation Ice Machine Operation SectionInitial START-UP or START-UP After Automatic SHUT-OFF QM45 SELF-CONTAINED AIR Cooled Models Siphon System Operational ChecksSiphon System Check Water Level CheckIce Thickness Check ICE Thickness CheckThis page Intentionally Left Blank Section Maintenance Section MaintenanceInterior Cleaning and Sanitizing Cleaning and Sanitizing ProcedureMaintenance Section Water Distribution Tube Disassembly DisassemblyRemove the Water Distribution Tube Water Distribution Tube RemovalRemove the Water Trough InstallationRemove the Ice Damper Remove the Bin Door Model Cleaning the Condenser Exterior CleaningICE Machine Inspection Air-Cooled CondenserSELF-CONTAINED AIR-COOLED ICE Machines Removal from Service WinterizationBefore Calling for Service Section Before Calling for ServiceChecklist Safety Limit Feature Before Calling for Service SectionSafety Limit Stand-By Mode Safety LimitsDetermining Which Safety Limit Stopped The Ice Machine Safety Limit NotesSafety Limit #2 Safety Limit #1Page Manitowoc ICE, INC