Manitowoc Ice QM45 Series Remove the Water Trough, Remove the Ice Damper, Installation

Page 26

Maintenance

Section 4

F. Remove the Water Trough

Apply downward pressure on the siphon tube and remove from the bottom of the water trough.

Remove the upper thumbscrew.

While supporting the water trough remove the two thumbscrews from beneath the water trough.

Remove the water trough from the bin area

G. Remove the Ice Damper

Grasp ice damper and apply pressure toward the left hand mounting bracket.

Apply pressure to the right hand mounting bracket with thumb.

Pull ice damper forward when the right hand ice damper pin disengages.

UPPER

THUMBSCREW

SV1689-1

LOWER

REMOVE SIPHON

 

 

 

THUMBSCREWS

TUBE

 

 

Installation

 

 

 

 

 

 

 

Place ice damper pin in left hand mounting bracket and apply pressure toward the left hand mounting bracket.

Apply pressure to the right hand mounting bracket with thumb.

Push ice damper toward evaporator until right hand damper pin engages.

4-4

Image 26
Contents Installation, Use, Care QM45 Series Ice MachinesThis manual covers the following model numbers Safety NoticesProcedural Notices Table of Contents Checklist Safety Limit Feature Safety Limits MaintenanceBefore Calling for Service Section General Information AccessoriesSection General Information Model NumbersModel/Serial Number Location General Information SectionModel/Serial Number Location Owner Warranty Registration Card Commercial Warranty CoverageResidential Warranty Coverage WHO is Covered by this Limited WARRANTY?Ice Machine Dimensions Section Installation InstructionsInstallation Instructions SectionIce Machine Heat of Rejection Installation Instructions SectionLocation of Ice Machine Leveling Leg and Foot Leveling the Ice MachineLeveling LEGChecking Ice Machine Level This page Intentionally Left Blank Voltage Electrical ServiceFor United Kingdom Only QM-45 ICE Machine FUSE/CIRCUIT BreakerWater Inlet Lines Water Service/DrainsWater Supply Drain ConnectionsTypical Water Supply Drain Installation Water Supply and Drain Line SIZING/CONNECTIONSPersonal Injury Potential Installation ChecklistBefore Starting the Ice Machine Component Identification Section Ice Machine OperationIce Machine Operation Initial START-UP or START-UP After Automatic SHUT-OFF Ice Machine Operation SectionIce Making Sequence of Operation QM45 SELF-CONTAINED AIR Cooled Models Siphon System Check Operational ChecksSiphon System Water Level CheckICE Thickness Check Ice Thickness CheckThis page Intentionally Left Blank Interior Cleaning and Sanitizing Section MaintenanceSection Maintenance Cleaning and Sanitizing ProcedureMaintenance Section Remove the Water Distribution Tube DisassemblyWater Distribution Tube Disassembly Water Distribution Tube RemovalRemove the Ice Damper InstallationRemove the Water Trough Remove the Bin Door Model ICE Machine Inspection Exterior CleaningCleaning the Condenser Air-Cooled CondenserRemoval from Service Winterization SELF-CONTAINED AIR-COOLED ICE MachinesChecklist Section Before Calling for ServiceBefore Calling for Service Before Calling for Service Section Safety Limit FeatureDetermining Which Safety Limit Stopped The Ice Machine Safety LimitsSafety Limit Stand-By Mode Safety Limit NotesSafety Limit #1 Safety Limit #2Page Manitowoc ICE, INC