Matsushita CF-Y5LWVYZ 1 2 service manual Assembly of the Touch Pad, Pad Cover Externals

9.3.4.5. Assembly of the Touch Pad

Affixes Pad Cover Tape

Release coated paper "NITTO No5000"

Print side

Thing that doesn’t begin to be seen from window of Pad Cover

It sticks it according to U convex part.

Safety work

Division attention of Pad Cover

ZA-0 = It is about the hemicycle. YA-0 = There is no hemicycle.

Pad Cover

<preparation for PAD>

			After of two PAD preparation completion
			It installs in the pressurizing treatment
			device and it pressurizes it.
			(Range of shaded portion)
	Pad FFC is inserted
Reinforcement board side
PAD that has been
prepared is stuck.	Insertion
	after PAD is
	pressurized
		Sticking
	It sticks it	part externals	Pad Cover Externals
Release coated paper	according to		The gap is
	U convex part		0.2 or less
"NITTO No5000"
Print side			<FIG2>
Thing that doesn’t	Affixes		The hole of a transparent mount of
begin to be seen	Pad Cover Tape		PAD WP SHEET is inserted in the
from window of			pin of the treatment device.
Pad Cover

	<Preparation for PAD-2>		Touch Pad		PAD position-determining pin
Pad Cover
	Sticking part externals
	and externals match of		Pad WP Sheet
	Pad Case of sticking PAD
	that has been prepared.
1. PAD is installed on the treatment device		<FIG2>
and it installs it between positioning
the installation three places.
2.The yellowish brown flaking off paper side
of Pad WS Sheet is peeled off and			PAD positioning spacer		PAD positioning spacer
the positioning hole of a transparent
mount is inserted in the pin of the		The hole of a transparent mount of
treatment device.
3. The sticking part of PAD and WP Sheet is		PAD WP SHEET is inserted in the		<FIG:1Preparation for PAD-1>
		pin of the treatment device.
pressurized.

50