Matsushita CF-Y5LWVYZ 1 2 service manual DFHE5035ZB, Cpu

9.3.6.6. Assembly of the DC Jack Plate

The LCD cable must pass the Safety work

side of the DC MDM cover

Set DC-IN Jack Plate

Prevent metal fittings from running aground in the rotation stopper

Set DC MDM Cover

Fix the DC-IN cable with a couple-face tape of the botto case preparation

Put the FAN Sheet

Tighten DXQT2+E6FNL

Set Jack.

Put the cylinder part in the bottom case hole

LCD cable/DC-IN cable processing

Black lead side Be lower to the right
Red lead side	under until hits the
	Bottom Case, and
Be sure to stick in parallel in	along the Bottom
	Case difference side
a red line and a black line .
	of the cable
Be careful not to come in
succession.	Peel off the flaking off
	paper of a couple-face
	tape of the bottom case
	preparation, and process
	the DC-IN cable

FAN sheet pasting position

	0-0.5	Be careful not to run
Outside diameter		aground in this platform
	Pressurize back
of boss
	side a couple-face SheetFAN		0-0.5
0-0.5	tape part of the		(0-1)
	FAN seat	Bottom Case
Put the DC-IN Cable		Red lead sideBlack lead side
under the substrate
too much.	Antenna Cable
Do not cross with	Incert the Connector
the Antenna Cable.

9.3.6.7. Putting Main PCB Sheet

Only turn affixation is executed without the cable when there is no W-LAN.

After Screw is concluded, the hole gap prevention tool is temporarily tightened

Maintain the antenna cable in the part a brim in the Main Board insulating sheet

Match the corner hole to CPU chip and put

		DFHE5035ZB		Antenna
Tighten K1YE5000022			A
A	B	K1YE5000022

Put Main Board Insulating Sheet

hole

Antenna cable processing

Confirm the thing which	Set the cable to the slit part
	of the seat, turn the sheet,
can be operated in the	and affix
cable tape maintenance
part

After holding a part of the Main Board insulation sheet on inside-out and a tape, stuck the Main Board insulation sheet on a regular position.

B

	CPU Chip
CPU
externals	CPU externals

72