Matsushita CF-Y5LWVYZ 1 2 Removing the Top Case, Preparation perform the .2.1., 9.2.3. first

5.KB side cover (L) is adjusted to the upper part as well as KB side cover (R), the minus clock driver removes hook (C-1) in the hook position from the space with the bottom case, rotates to the key- board side, and detaches.

	Hook (C-1)
	Hook (C-1)
KB Side Cover (L)
	Hook (C-2)
LCD Unit	Hook (C-2)

9.2.4. Removing the Top Case

Preparation : perform the section 9.2.1., 9.2.3. first.

1.Remove the 2 screws (E) and 2 foot rubber backs. Screw (E) : XTB26+10GFN (N12)

2.Remove the 5 screws (F). Screw (F) : DXHM0057ZA (N5)

3.Remove the 2 screws (G). Screw (G) : DXHM0049ZA (N3)

4.Remove the 1 screw (H) and 1 screw (I ). Screw (H) : DXQT2+D4FNL (N7)

Screw (I ) : DXQT2+E10FNL (N8)

Foot Rubber Back

Screw (E)

6.The both sides tape pasted to the keyboard bottom with the spatula is inserted in order of the arrow and then peel off. It is start-up from the LCD side and turns inside out on the top case.

The KBD FPC WP sheet is peeld off, FFC (key- board) is removed from connector (CN25) and (CN24), and then remove the keyboard.

Bottom Case

Screw (G)

Screw (F)

Screw (F)

Screw (I)

Screw (H)

Screw (G)

Foot Rubber Back

Screw (E)

Screw (F)

Screw (F)

Screw (F)

Spatula

Do not damage the spatula ahead and move a top case in the

direction of the arrow in order.

KBD FPC WP Sheet CN24

CN25

5.Operate the LCD knob and open the LCD Unit to an angle of 90 degrees or more.

6.The hook 2 places of the disk side cover are re- moved, and detaches forward while rotating in the direction of the upper surface.

7.The disk cover lock is mechanically released, and the disk cover is opened.

LCD Unit

Disk Cover

Keyboard	Back Side	Hook (D)
	Both Sides Tape

Note:
KBD-FPC sheet cannot be recycled. Please use new	Disk Side Cover
parts.	Mechanical Release Lever

26