Manitowoc Ice S1000M Electrical Service, Voltage, Fuse/Circuit Breaker, Minimum Circuit Ampacity

Page 11

Electrical Service

Section 2	Installation Instructions

Electrical Service

GENERAL

!Warning

All wiring must conform to local, state and national codes.

VOLTAGE

The maximum allowable voltage variation is ±10% of the rated voltage at ice machine start-up (when the electrical load is highest).

!Warning

The ice machine must be grounded in accordance with national and local electrical codes.

FUSE/CIRCUIT BREAKER

A separate fuse/circuit breaker must be provided for each ice machine. Circuit breakers must be H.A.C.R. rated (does not apply in Canada).

MINIMUM CIRCUIT AMPACITY

The minimum circuit ampacity is used to help select the wire size of the electrical supply. (Minimum circuit ampacity is not the ice machine’s running amp load.)

The wire size (or gauge) is also dependent upon location, materials used, length of run, etc., so it must be determined by a qualified electrician.

ELECTRICAL REQUIREMENTS

Refer to Ice Machine Model/Serial Plate for voltage/ amperage specifications.

Important

Observe correct polarity of incoming line voltage.

S Series Marine Ice Machines

	Ice Machine	Voltage Phase		Water Cooled
		Voltage Phase	Maximum Fuse/Circuit
		Cycle	Maximum Fuse/Circuit		Minimum Circuit Amps
		Cycle	Breaker		Minimum Circuit Amps
			Breaker
		208-230/1/60	20		12.6
	S1000M	208-230/3/60	15		8.9
		230/1/50	20		11.2

Part Number 80-1561-3

2-3

Image 11

Contents S1000M Model Ice Machines Installation Use and Care ManualProcedural Notices Read These Before ProceedingPERSONAL INJURY POTENTIAL Safety NoticesAuCS Automatic Cleaning System Table of Contents continued Section General InformationSection Installation Instructions Manitowoc Cleaner and SanitizerGuardian Sachet Replacement Frequency Table of Contents continued Section Ice Machine OperationSection Maintenance Section Before Calling For ServiceGeneral Information How to Read a Model NumberSection General Information SectionBIN CASTER AccessoriesMANITOWOC CLEANER AND SANITIZER AUCS AUTOMATIC CLEANING SYSTEMMODEL/SERIAL PLATE LOCATION Model/Serial Number LocationModel/Serial Number Location Service Calls Owner Warranty Registration CardWarranty Coverage AUTHORIZED WARRANTY SERVICEWidth, Depth, and Height Dimensions Section Installation InstructionsInstallation Instructions Ice Machine DimensionsThe location must be free of airborne and other contaminants Location of Ice MachineIce Machine Heat of Rejection MINIMUM CIRCUIT AMPACITY Electrical ServiceVOLTAGE FUSE/CIRCUIT BREAKERSELF CONTAINED ICE MACHINE 208-230/3/60 Self-Contained Electrical Wiring ConnectionsFor United Kingdom Only SELF CONTAINED ICE MACHINE 115/1/60 OR 208-230/1/60AIR GAP Water Supply and Drain RequirementsCooling Tower Applications Water-Cooled Models WATER SUPPLYPlumbing must conform to state and local codes Typical Water Supply Drain InstallationWATER SUPPLY AND DRAIN LINE SIZING/CONNECTIONS Is the Ice Machine level? Installation Check ListPotential Personal Injury Situation Before Starting the Ice Machinesv3149 Section Ice Machine OperationIce Machine Operation Component IdentificationFREEZE SEQUENCE 3. Prechill Sequence Of OperationINITIAL START-UP OR START-UP AFTER AUTOMATIC SHUT-OFF 1. Water Purge 2. Refrigeration System Start-UpAUTOMATIC SHUT-OFF 7. Automatic Shut-Off SAFETY TIMERSHARVEST SEQUENCE 5. Water Purge 6. HarvestIce Thickness Check Operational ChecksWATER LEVEL ICE THICKNESS CHECK45 second setting 0 second setting Water Purge AdjustmentHARVEST SEQUENCE WATER PURGE THIS PAGE INTENTIONALLY LEFT BLANK Ice Machine Inspection Section MaintenanceMaintenance Exterior CleaningGuardian SACHET INSTALLATION/REPLACEMENT PROCEDUREGuardian Location GUARDIAN SACHET REPLACEMENT FREQUENCY CLEAN UP PROCEDURE FOR DAMAGED SACHET PACKETStep Interior Cleaning and SanitizingCLEANING PROCEDURE Remove all ice from the bin SANITIZING PROCEDURERefer to Removal of Parts For Cleaning 1 gal. 4 l REMOVAL OF PARTS FOR CLEANING/SANITIZINGCleaner 16 oz 500 ml cleanerIce Thickness Probe Removal 1. Water CurtainWater Curtain Removal 2. Ice Thickness ProbeWater Distribution Tube Removal 3. Water Distribution Tube4. Water Trough Water Pump Removal Water Level ProbeWater Pump COIL SPRING Dump Valve DisassemblyWater Dump Valve PLUNGER SPRING STOPDrain Line Check Valve 4-10Evaporator Tray Removal Panel Removal Removing the Front Panel4-11 Water Inlet ValveSELF-CONTAINED WATER-COOLED ICE MACHINES Removal from Service/WinterizationPry Open the Water Regulating Valve AUCS→ Accessory 4-12Problem Section Before Calling For ServiceBefore Calling For Service ChecklistCall for service Safety Limit FeaturePage 2004 Manitowoc Ice, Inc. Litho in U.S.A MANITOWOC ICE, INC