Manitowoc Ice S1000M manual Water Level Probe, Water Pump Removal, Maintenance, Section

Page 30
Water Level Probe

Maintenance

Section 4

 

 

Water Level Probe

1. Remove the water trough.

!Warning

Disconnect the electrical power to the ice machine at the electrical disconnect before proceeding.

2.The water level probe normally does not require removal for cleaning. The probe can be wiped and cleaned in place or proceed to step 3.

3.Pull the water level probe straight down to disengage.

4.Lower the water level probe until the wiring connector is visible. Disconnect the wire lead from the water level probe.

5.Remove the water level probe from the ice machine.

WATER LEVEL PROBE

SV3141

Water Pump

!Warning

Disconnect the electric power to the ice machine at the electric service switch box and turn off the water supply before proceeding.

1.Empty the water trough.

A.Move the toggle switch from OFF to ICE.

B.Wait 45 seconds.

C.Place toggle switch in OFF position.

WATER

PUMP

SV3091

Water Pump Removal

2.Remove the water trough.

3.The water pump normally does not required removal for cleaning. The water pump base can be wiped and cleaned in place or proceed to step 4.

4.Grasp pump and pull straight down on pump assembly until water pump disengages and electrical connector is visible.

5.Disconnect the electrical connector.

6.Remove the water pump assembly from ice machine.

7.Do not soak the water pump in cleaner or sanitizer. Wipe the pump and ice machine base clean.

4-8

Part Number 80-1561-3

Image 30
Contents Installation Use and Care Manual S1000M Model Ice MachinesSafety Notices Read These Before ProceedingPERSONAL INJURY POTENTIAL Procedural NoticesManitowoc Cleaner and Sanitizer Table of Contents continued Section General InformationSection Installation Instructions AuCS Automatic Cleaning SystemSection Before Calling For Service Table of Contents continued Section Ice Machine OperationSection Maintenance Guardian Sachet Replacement FrequencySection How to Read a Model NumberSection General Information General InformationAUCS AUTOMATIC CLEANING SYSTEM AccessoriesMANITOWOC CLEANER AND SANITIZER BIN CASTERModel/Serial Number Location Model/Serial Number LocationMODEL/SERIAL PLATE LOCATION AUTHORIZED WARRANTY SERVICE Owner Warranty Registration CardWarranty Coverage Service CallsIce Machine Dimensions Section Installation InstructionsInstallation Instructions Width, Depth, and Height DimensionsLocation of Ice Machine Ice Machine Heat of RejectionThe location must be free of airborne and other contaminants FUSE/CIRCUIT BREAKER Electrical ServiceVOLTAGE MINIMUM CIRCUIT AMPACITYSELF CONTAINED ICE MACHINE 115/1/60 OR 208-230/1/60 Self-Contained Electrical Wiring ConnectionsFor United Kingdom Only SELF CONTAINED ICE MACHINE 208-230/3/60WATER SUPPLY Water Supply and Drain RequirementsCooling Tower Applications Water-Cooled Models AIR GAPTypical Water Supply Drain Installation WATER SUPPLY AND DRAIN LINE SIZING/CONNECTIONSPlumbing must conform to state and local codes Installation Check List Is the Ice Machine level?Before Starting the Ice Machine Potential Personal Injury SituationComponent Identification Section Ice Machine OperationIce Machine Operation sv31492. Refrigeration System Start-Up Sequence Of OperationINITIAL START-UP OR START-UP AFTER AUTOMATIC SHUT-OFF 1. Water Purge FREEZE SEQUENCE 3. Prechill6. Harvest SAFETY TIMERSHARVEST SEQUENCE 5. Water Purge AUTOMATIC SHUT-OFF 7. Automatic Shut-OffICE THICKNESS CHECK Operational ChecksWATER LEVEL Ice Thickness CheckWater Purge Adjustment HARVEST SEQUENCE WATER PURGE45 second setting 0 second setting THIS PAGE INTENTIONALLY LEFT BLANK Exterior Cleaning Section MaintenanceMaintenance Ice Machine InspectionCLEAN UP PROCEDURE FOR DAMAGED SACHET PACKET SACHET INSTALLATION/REPLACEMENT PROCEDUREGuardian Location GUARDIAN SACHET REPLACEMENT FREQUENCY GuardianInterior Cleaning and Sanitizing CLEANING PROCEDUREStep SANITIZING PROCEDURE Refer to Removal of Parts For CleaningRemove all ice from the bin 16 oz 500 ml cleaner REMOVAL OF PARTS FOR CLEANING/SANITIZINGCleaner 1 gal. 4 l2. Ice Thickness Probe 1. Water CurtainWater Curtain Removal Ice Thickness Probe Removal3. Water Distribution Tube 4. Water TroughWater Distribution Tube Removal Water Level Probe Water PumpWater Pump Removal PLUNGER SPRING STOP Dump Valve DisassemblyWater Dump Valve COIL SPRING4-10 Evaporator Tray RemovalDrain Line Check Valve Water Inlet Valve Removing the Front Panel4-11 Panel Removal4-12 Removal from Service/WinterizationPry Open the Water Regulating Valve AUCS→ Accessory SELF-CONTAINED WATER-COOLED ICE MACHINESChecklist Section Before Calling For ServiceBefore Calling For Service ProblemSafety Limit Feature Call for servicePage MANITOWOC ICE, INC 2004 Manitowoc Ice, Inc. Litho in U.S.A