
Installation Instructions
STEP 9 INSTALL FRAMED PANELS | Right hand models shown. Use the same instructions for |
| left hand models. |
| IF YOU ARE INSTALLING OVERLAY PANELS, GO |
| TO STEP 9A. |
Handle | Door Trim |
Trim |
|
| Refrigerator |
| Door |
Use Front Holes
to Secure TrimStandard supplied handle shown in 1/4" panel position.
Use Rear Holes
to Secure Handle
Install door and drawer panels:
•Open door to 90°. Remove the 4 Phillips head screws from the door handle.
•Remove handle. Retain all screws.
•Remove 4 screws holding trim, lift off trim. Retain screws.
•Slide framed panel into the door trim.
•There are two sets of holes in the handle side trim. Replace handle side trim by installing the original screws in the FRONT screw holes.
•Secure the handle to the door using the REAR screw holes.
•Follow the same procedures to install the drawer panel.
Custom handles
If you are using custom handles, the handle must be properly secured to the panel before sliding the panel into the trim.
•The cabinet manufacturer will supply the custom handle and hardware.
•Secure the door/drawer trim using both the FRONT and REAR screw holes. Discard supplied handle.
14