GE Monogram ZICS360N LH Tools Required, Hardware Supplied, Materials Required, Flooring

Page 9

Installation Instructions

TOOLS REQUIRED

Tinsnips to cut banding

Stepladder

Bucket

Level

Appliance Hand Truck

Tubing cutter

7/16" open-end wrench

#2 Phillips screwdriver

Drill and appropriate bits

5/16", 7/16" socket

Safety glasses

1-1/4" open end wrench

Pliers

HARDWARE SUPPLIED

Water filter bypass plug

Anti-Tip brackets

Special 3M Dual Lock adhesive strips for 1/4" side panels

1/4" nut and ferrule

MATERIALS REQUIRED

35" long 2x4 for Anti-Tip support

Copper water line tubing

Water shut-off valve (optional but recommended)

Custom panels for fresh food door, freezer drawer and grille panel

Screws to secure refrigerator to cabinetry.

FLOORING

For proper installation, this refrigerator must be placed on a level surface of hard material that is at the same height as the rest of the flooring. This surface should be strong enough to support a fully loaded refrigerator, or approximately 700 lbs.

NOTE: Protect the finish of the flooring. Cut a large section of the cardboard carton and place under the refrigerator where you are working.

GROUNDING THE REFRIGERATOR

IMPORTANT - (Please read carefully)

FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED.

The power cord of this appliance is equipped with a three-prong (grounding) plug which mates with a standard three-prong (grounding) wall receptacle to minimize the possibility of electric shock hazard from this appliance.

Have the wall outlet and circuit checked by a quali- fied electrician to make sure the outlet is properly grounded.

Where a standard 2-prong wall outlet is encountered, it is your personal responsibility and obligation to

have it replaced with a properly grounded 3-prong wall outlet.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE THIRD (GROUND) PRONG FROM THE POWER CORD.

DO NOT USE AN ADAPTER PLUG TO CONNECT THE REFRIGERATOR TO A 2-PRONG OUTLET.

DO NOT USE AN EXTENSION CORD WITH THIS APPLIANCE.

9

Image 9
Contents Installation Instructions Before YOU Begin ContentsDimensions and Clearances Installation SpaceDoor Swing Optional setting Scale Customization Basics Overlay Panel Dimensions Framed Panel DimensionsSide Panels ZUG2 Grille Panel DimensionsHardware Supplied Tools RequiredMaterials Required FlooringInstall Water Line Remove PackagingShut off the main water supply Install Side Panels Water Line Installation with a Reverse Osmosis SystemInstall ANTI-TIP Brackets Skip this step when not using an RO SystemLevel Refrigerator Secure Refrigerator To CabinetryRefrigerator must be secured to prevent tipping Install Grille Panel Adjust Door SwingInstall door and drawer panels Install Framed PanelsRight hand models shown. Use the same instructions for Left hand modelsCustom handles Install Toekick Connect PowerConnect Water Supply Start IcemakerPage Page Page Monogram