Installation
Remove the screws from the countertop.
Lift the appliance back out of the cabinet.
Tighten the mounting brackets on the appliance at the marked position.
Lay the vent housing on the floor on a blanket or other suitable protection in order to mount the DAG 500 blower or DAG 1000 blower adapter.
Decide on the venting direction.
If the ventilation system is installed in a cabinet, the vent duct can go through the floor, the right or left side, or to the rear of the cabinet.
Installing the DAG 500 blower box on the front
Venting to the side or downwards:
Plug the connection cable from the ventilation system into the blower motor.
Turn the blower box so that the vent collar faces in the desired direction – left, right or downwards.
Mount the blower box to the housing with 4 screws.
28