Setting the serving sizes
Hot water
To program the volume of hot water dispensed, the hot water feature must be programmed "on".
(See "Programming/Hot water feature").
^Turn the program selector clockwise to the "On" position (with or without lighting).
The following will appear in the message window:
If the machine is cold and the rinsing feature has been selected, the following message will then be displayed:
Once the water is hot, the following will appear in the message window:
^Place a cup under the hot water dispenser.
^Press and hold the hot water button d. There will be a few seconds delay before water is dispensed.
When the cup is full as desired release the hot water button d.
The following appears in the message window during this procedure:
If the feature "Prog. hot water" is "off", the machine will continue to dispense hot water until the hot water button d is pressed again.
26