Building in the appliance
^Loosen screws b on the top and bottom fixing brackets c.
^Press fixing bracket c against the side wall and tighten screws b.
^Attach fixing bracket c to the housing unit side wall with screws d. Drill holes in the housing unit side walls if necessary.
^Break off the protruding end of top cover e, turn the cover around and fit it on top fixing bracket c.
^Fit oblong cover f onto top fixing bracket c.
^Break off the protruding end of bottom cover e. It is no longer required.
^Fit angled cover g onto bottom fixing bracket c.
^Close the appliance door.
Fitting a furniture door
^A gap of 8 mm a must be set between the appliance door and the central fixing bracket.
^Push fitting aids b up to the height of the furniture door: the lower edge X of the fitting aids must be at the same height as the upper edge of the furniture door being fitted (see - on the diagram).
^Undo nuts c and take fixing bracket d off together with the fitting aids.
45