Building in the appliance
Building in the appliance
^Fit cover g onto fixing bracket h.
^Secure fixing bracket h to the bottom of the appliance with screws i (M5 x 15).
^Carefully remove the protective foil from sealing strip j.
^Apply the sealing strip to the side of the appliance on which the door is opened so that it is flush with the front edge of the appliance.
Fit the sealing strip so that it meets up with the lower edge of top cover d and then cut the sealing strip
2 - 3 mm above bottom fixing bracket h.
^Push the appliance into the niche until covers d and g touch the front edge of the side walls of the housing unit.
–With 16 mm thick walls:
The spacers should touch the front edge at the top and bottom of the side walls of the housing unit, detail a.
–With 19 mm thick walls:
The front edges of the top and bottom hinges sit flush with the front edge of the housing unit side walls, detail b.
^Make sure that the covers on the top and bottom fixing brackets sit flush with the front edges of the housing unit side walls, detail d.
This will create a gap all round of 42 mm to the front edges of the housing unit side walls.
43