Miele KF 7544 installation instructions Changing over the door handle, Refitting the doors

Page 39

Changing the door hinging

^Pull bearing bush d downwards out of hinge bracket e and refit it from above into the hinge bracket.

^Use a screwdriver to remove spacer g and refit it on the opposite side.

Changing over the door handle:

^Remove covers m at the front and slide off to the side.

^Unscrew handle k. Refit handle and stoppers l on the opposite side.

^Slide covers m into position making sure they engage correctly.

Refitting the doors:

^Remove plugs j from door bearing bushes in the doors and refit on the opposite side.

^Hang the upper appliance door on hinge pin c, and close the appliance door.

^Push middle hinge pin f from below through hinge bracket e into the up- per appliance door.

^Check that the door is correctly aligned. If necessary align it using the long slots in hinge bracket e.

^Hang the lower door in hinge bracket e then close the appliance door.

In the following illustration the lower door is not shown in the closed posi- tion to make it easier to see what happens next.

^Turn door support b around, pull hinge pin a out, and refit on the op- posite side.

^Fit both parts into hinge plate f. To do this push hinge pin a through hinge plate f into door support b. Swing door support out, push up- wards and re-assemble with screw c.

^Align the lower door with the appli- ance housing using the long slot in hinge plate f. Then tighten screw c.

^Refit plinth fascia d pushing it firmly into position.

^With the lower door open, secure cover e to the front of the plinth fas- cia.

39

Image 39
Contents Page Contents Contents Description of the appliance Description of the appliance Caring for the environment Disposal of the packing materialDisposal of your old appliance Correct use Technical safetyOperation Page Disposal of your old appliance Switching off Switching on and offBefore using for the first time Switching onCool pack Switching off the alarmSafety lock Switching off for longer periods of timeRefrigerator Correct temperatureTemperature selection FreezerTemperature displays Temperature display brightness Temperature displays flash, ifSwitching the alarm tone off early AlarmTemperature alarm Door alarmSuper cool Switching on super coolSwitching off super cool Super cool, super freeze and dynamic coolingDynamic cooling Super freezeColdest zone Using the refrigerator section efficientlyDifferent storage zones Food which should not be stored in a refrigeratorStoring food correctly Energy saving tipsFruit and vegetables Split shelf Adjusting the interior fittingsAdjusting the door shelves Moving the shelvesHome freezing Freezing and storing foodMaximum freezing capacity Storing frozen foodBefore placing food in the freezer PackingSuitable packing material Unsuitable packing materialMarker system for frozen food Freezer calendarDefrosting Ice cubesCooling drinks Freezer tray Defrosting Refrigerator sectionFreezer section Cloth Cleaning and careBefore cleaning Cleaning the outer casing, the interior and accessoriesMetal grille at the back of the appliance After cleaningVentilation gaps Door sealsAppliance does not get cool Problem solving guideFollowing message appears in the temperature display nA Appliance is switching in too frequently and for too longBar is lit up or flashing in the temperature displays Following messages show in the temperature display F0 to F5Floor of the refrigerator sec- tion is wet Interior light in the refrigerator section is not workingAfter Sales Service Electrical connection U.K Electrical connectionNon-rewireable plugs BS Fitting the handles InstallationLocation VentilationInstallation Aligning the appliance Open the lower appliance door Changing the door hingingRefitting the doors Changing over the door handleBuilding in the appliance Page Page Page Änderungen vorbehalten