Operating your radio - FM auto tune
1. | Carefully extend the telescopic aerial fully and press the On/Off button |
|
|
| to switch on your radio. | 1,9 | 2 |
|
| ||
2. | Press and release the DAB/FM/AUX button to select the FM band. |
|
|
3.Press and release the Auto Tune button to cause your radio to scan in the direction previously scanned and stop automatically when it fi nds a station of suffi cient strength.
4.After a few seconds the display will update. The display will show the frequency of the signal found. If the signal is strong enough and there is RDS data present then the radio will display the station name.
5.To fi nd additional stations press and release the Auto Tune button as before.
6.To scan the FM band in a opposite direction either rotate the Tuning/ SelectcontrolclockwiseoruseTuningUpbutton(toscanlowfrequency to high frequency) or rotate
3,5,6
6
7.When the end of the waveband is reached your radio will recommence tuning from the opposite end of the waveband.
8.Adjust the Volume and Tone controls to the required settings.
9.To switch off your radio press the On/Off button.
If you need any further advice, please call our Technical Helpline on :-
8 8
8
If you fi nd that an FM broadcast has a lot of background hiss, this may often be reduced by setting the radio into Mono reception mode for the current FM station. Please refer to the section "Stereo / Mono setting - FM" on page 17 for further details.
020 8758 0338
14