FULL SIZE ELECTRIC CONVECTION OVENS - SERVICE PROCEDURES AND ADJUSTMENTS
6.With the doors closed, observe the position of the catch roller "ball" in relation to the door strike.
A.Ensure the catch roller "ball" is centered (left to right) to the door strike.
1)Adjust alignment, if necessary.
B.Open the right side door and view the left side door catch roller and strike. Ensure the door catch roller "ball" is resting upon the angular surface of the door strike. Repeat on the opposite door.
1)If adjustment is necessary, loosen the mounting screws then slide the door strike from "front to back" until the roller rests upon the angular surface of the door strike. Tighten screws and check operation.
2)If proper adjustment cannot be achieved, add shims beneath the door strike. Repeat step 6 thru this step. DO NOT BEND THE DOOR STRIKE.
7.Each oven door should open with a force of 8 to 25 pounds when pulled at the handle. See "TOOLS" under "GENERAL".
A.Adjust catch roller tension as follows:
1)Turn the set screw inside the catch assembly housing clockwise to increase tension on the catch roller and counterclockwise to decrease tension on the catch roller.
NOTE: The amount of tension on the catch roller determines the opening force of the door.
2)Continue adjustment until proper door operation is achieved.
DOOR SWITCH ADJUSTMENT
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AT THE MAIN CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT BOX INDICATING THE CIRCUIT IS BEING SERVICED.
1.Remove the top front cover as outlined under "COVERS AND PANELS" in "REMOVAL AND REPLACEMENT OF PARTS".
2.Door operation:
A.Independent doors - The switch actuator should be operated by the switch lever when the right door is between 1" and 1 ½ " from being closed.
B.Simultaneous doors - The switch actuator should be operated by the switch lever when the right door is ½ " from being closed.
3.If adjustment is necessary, bend the switch actuator to obtain the proper setting.
4.Install the top front cover.
5.Apply power to the oven and check for proper operation.
DOOR CHAIN ADJUSTMENT (SIMULTANEOUS DOORS)
Introduction
When the oven doors are in proper adjustment, as the doors come together, the right door will lead the left door in closing by about 1/4 inch. The doors will feel like they are self closing the last ½ inch of travel.
Procedure
1.Remove the lower sill cover as outline under "COVERS AND PANELS" in "REMOVAL AND REPLACEMENT OF PARTS".
2.Close doors and check door chain for factory setting.
Page 23 of 60 |
| F25105 (December 2001) |
|