Russound CAM6.6X-S1/S2 instruction manual KEY Name, Device Code, KEY Function

Select the zone the key will be configured for. Changes are made for that zone only; default setting is “All Zones.”

Select the source the key will be configured for.

INSTALLER

INSTALLATION MENU

KEY CONFIG (KeyCf)

Key Configuration defines zone-specific key functions for each source. See Key Config. - Flow Chart page 70

1. ZONE NUM – (Zone#)

2.SOURCE NUM – (Src #)

3.SELECT A KEY – (SelKy)

4.KEY TYPE – (KeyTp)

Using or , select the keypad key to be configured.

Either “Key Press,” “Key Hold” or “Both” will activate the command.

5. KEY NAME –	Name that appears on the keypad display when the command is
(KeyNm)	activated.
6. COMMAND TYPE –	Select the type of source command (e.g., CD, TV, etc.).
(CmdTp)
a. Selected: Learned IR – Choose Learned IR if the pre-programmed IR code library does
(LrnIR)	not support the source component.
i. LEARNED SRC –	Select the learned source bank to be assigned to the source
(LnSrc)	component. Procedure advances to KEY FUNCTION (step 8)
b. Selected: Unassigned	The key configuration is cleared. Procedure advances to SAVE
(Unasg)	CHANGES (step 9)
c. Selected: Default	Default selects the same device type and device code previously
(Deflt)	setup in BASIC SETUP. Procedure advances to KEY FUNCTION
	(step 8)
d. Selected: Macro:	(To build macros, see Macro Editor page 65)
i. MACRO -	Macro loads a series of commands which are processed when
(Macro)	activated.
ii. MACRO ID –	Enter the macro ID number. Menu advances to SAVE CHANGES
(MacID)	(step 9)
e. All Other Selections:	Procedure advances to DEVICE CODE (step 7)
7. DEVICE CODE –	Enter source component code number listed in this manual’s
(DevCd)	Reference section.
8. KEY FUNCTION –	Select a function for the button.
(KeyFn)	57