Russound CAM6.6X-S1/S2 ZON VOL Trim, ZonVT Each zone. -16 dB lowest to 0 dB max-3dB default

	INSTALLER
	INSTALLATION MENU
c. Selected: Default	Default selects the same device type and device code previously
(Deflt)	setup in BASIC SETUP. Procedure advances to KEY FUNCTION
	(step 4)
d. Selected: Macro:	(To build macros, see Macro Editor page 65)
i. MACRO -	Macro loads a series of commands which are processed when
(Macro)	activated.
ii. MACRO ID –	Enter the macro ID number. Menu advances to SAVE CHANGES
(MacID)	(step 5)
e. All Other Selections:	Procedure advances to DEVICE CODE (step 3)
3. DEVICE CODE –	Source component code for IR control.
(DevCd)
4. KEY FUNCTION –	Select a function (Play, Enter, etc.).
(KeyFn)
5. SAVE CHANGES? –	Select “yes” to save the changes.
(Save?)

# OF SOURCES (#Srcs)

At this field it is necessary to enter the number of sources used in the CAM6.6 system (1 to 6). This limits the sources displayed on the keypad in the normal running mode when the source button is pressed, but also limits source selections in the configuration menus. See Source Select

Command & # Of Sources - Flow Chart page 73

ZONE SETUP (ZonSu)

NOTE: This procedure should be performed using the keypad installed in the zone to be configured.

See Zone Setup - Flow Chart page 74

Zone Setup allows the installer to adjust properties of the UNO Keypad controlled CAM6.6 zone. This series of menus allows the system’s zones to be configured for these properties:

ZON VOL TRIM (ZonVT)		SYSON ENABLE (SysOn)	PARTY ENABLE (PtyEn)
MASTER ENABL (MstEn)		MUTE ENABLE (MutEn)
1.	ZON VOL TRIM -	This feature allows the installer to adjust the output volume to
	(ZonVT)	each zone. -16 dB (lowest) to 0 dB (max)(-3dB default).
2.	SYSON ENABLE -	This feature is either disabled or enabled. If disabled (default), an
	(SysOn)	All On command activated from another zone will not turn on the

61