To replacehood lamp, first disconnectpowerat rnalnfuse or clrcult tweaker panel or pull plug.
Remove 2 screws from each side of lower panel, steady the $m@keand spatter shield with one hand while removing and replacing the 2 screws on each side. Then remove the 3 screws from front edge, Lower the panel until it rests on range below. Place
To replaceyour oven lamp,first disconnectpowerat mainfum or chcult breakeror pull plug.Removethe top grill by taking off 2 screws which hold it in place, Next, remove the single screw on top left that secures lamp housing, (On models so equipped.) Open oven door for easier removalof the lamp hous= ing assembly,Then grasp tab and pull out and up to clear door hinge and front lip of oven. To remove bulb, push it inward gently and turn to left, theri pull outward from socket, Replace with GE Lamp s 25?’8DC.
5%?A
fingers on top near each end of lamp. Press down and roll top of lamp gently toward front until it stops, Remove.Replacewith same type and wattage lamp, Hold lamp near each end and insert prongs in sockets, Gently roll top of lamp toward rear of range until it stops. Raiselower panel and replacescrews.
J
Clean off the grease and dust on hood surfaces often, Usea warm detergent solution. About 1table- spoon of ammonia may be added to the water. Take care not to touch the filters and enameled surfaces with this, Ammonia wINtend W darken metal, Wash the smoke and spatter shield with a warm detergent solution,
19
— | . |