Safety Instructions
Operating Instructions
Troubleshooting Tips
Consumer Support
About the dishwasher control panel.
You can locate your model number on the tub wall just inside the door. Throughout this manual, features and appearance may vary from your model.
PDW8700 Series and PDW8800 Series | 1 |
| 6 |
|
| 2 |
| |
| SENSING | SANITIZED | CLEAN |
|
|
|
| |
GLASSES |
|
|
|
|
|
|
|
|
CHINA |
|
|
|
|
|
|
| |
CRYSTAL |
|
|
|
|
|
|
| |
| 3 |
|
| 5 | 4 |
|
|
|
PDW9200 Series |
|
|
|
| 1 |
|
|
|
|
|
|
|
|
|
|
| |
CHINA CRYSTAL |
|
|
| SANITIZED |
|
|
| |
COOKWARE | RINSE ONLY |
|
|
| CLEAN |
|
|
|
NORMAL |
|
|
|
|
|
|
|
|
| 3 |
|
| 4 | 6 | 5 |
|
|
PDW9800 Series |
|
|
|
|
|
| 1 | 5 |
|
|
|
|
|
|
| ||
SPEED CYCLE | PLASTIC CYCLE |
|
|
| SENSING |
| DRYING | |
COOKWARE | CHINA CRYSTAL | RINSE ONLY |
|
|
|
| SANITIZED | |
NORMAL | GLASSES |
|
|
|
| WASHING |
| CLEAN |
2 | 3 |
|
|
| 4 |
|
| 6 |
1Status Indicator Lights (Indicators vary by model)
The Status display tells you what is happening while the dishwasher is in operation and may flash, indicating a malfunction. The lights will come ON, indicating the sequence of the dishwasher operation.
SENSING Displayed while the Clean Sensor™ is measuring the amount of soil and temperature of water. The dishwasher will adjust the selected cycle to achieve optimal performance.
WASHING Displayed during prewash, main wash and rinse periods.
DRYING Displayed during HEATED DRY.
SANITIZED Displayed when cycle has met sanitization conditions.
CLEAN Displayed when a wash cycle is complete.
2Time Remaining Display (on some models)
During operation, the display shows the minutes remaining until the cycle is complete. The display may adjust the remaining time while the Sensing light is on. The time displayed at the start of each cycle may change from the factory setting as the unit customizes itself to home use. During a delay start, the display will show hours of time remaining until the cycle starts.
3Selections
PDW8700 Series and PDW8800 Series: Press the pad for the desired wash cycle.
PDW9200 Series and PDW9800 Series: Use the Arrow Pads to scroll through the wash cycles.
NOTE: All cycle times and water usage information contained in the following section are approximate values only. Actual results will depend on several factors, including but not limited to, inlet temperature, household water pressure and turbidity of the wash water.
The light above or next to the selected pad will be ON to indicate which WASH CYCLE has been selected.
| This cycle raises the water temperature in the final rinse to sanitize your dishware. The | |
| cycle length will vary depending on the temperature of your inlet water. | |
| NOTE: The | |
| interrupted during or after the main wash portion or if the incoming water temperature is | |
| so low that adequate water heating cannot be achieved, the sanitizing conditions may not | |
4 | be met. In these cases, the sanitized light will not illuminate at the end of the cycle. | |
NOTE: | ||
|