GE PDW 9200 Using the dishwasher, Check the Water Temperature, Dish Preparation Prior to Loading

Page 8

Safety Instructions

Using the dishwasher.

Check the Water Temperature

The entering water should be at least 120°F and not more than 150°F for effective cleaning and to prevent dish damage. Check the water temperature with a candy or meat thermometer. Turn on the hot water faucet nearest the dishwasher, place the thermometer in a glass and let the water run continuously into the glass until the temperature stops rising.

Use Jet-Dry ® or Cascade Crystal Clear® Rinse Agent

Jet-Dry®or Cascade Crystal Clear® rinse agent improves drying, removes spots and prevents new film buildup on your dishes, glasses, flatware, cookware and plastic.

Instructions

Filling the Dispenser

The rinse agent dispenser holds 3.5 oz. of rinse agent. Under normal conditions, this will last approximately one month. Try to keep it full, but do not overfill.

1Make sure the dishwasher door is fully open.

Rinse Aid Setting

The amount of rinse agent released into the final wash can be adjusted. The factory setting is at the midpoint. If there are rings of calcium (hard water) spots on dishes, try a higher setting. If there is foaming, use a lower setting.

Operating

Tips

2Turn the dispenser knob to the left and

lift it out.

3 Add rinse agent until the indicator window looks full.

Clean up any spilled
4 rinse agent with a	Indicator
damp cloth.	window
damp cloth.	Dispenser cap

5Replace the dispenser cap.

To adjust the setting:

Remove the dispenser cap; then turn the adjuster counterclockwise to increase the amount

of rinse agent or clockwise to reduce

the amount of rinse agent.

Rinse agent adjuster

Dish Preparation Prior to Loading

■No prerinsing of normal food soil is required.

■Scrape off hard soils, including bones, toothpicks, skins and seeds.

■Remove large quantities of any remaining food.

Forget to Add a Dish?

■Remove leafy vegetables, meat trimmings and excessive amounts of grease or oil.

■Remove acidic food soils.

Troubleshooting

Consumer Support

	A forgotten dish can be added any time before			3	Add forgotten dishes.
	the main wash.			3	Add forgotten dishes.
	the main wash.				Close the door.
			Open the door slightly.	4	Close the door.
		1
		1
			Wait until the water spray action stops.
		2	Wait until the water spray action stops.
			Steam may rise out of the dishwasher.

8

Image 8

Contents Safety Instructions Loading Place SettingsWrite the model and serial numbers here Model # Serial # Flashing Display LightsTroubleshooting Tips Turning the switch on before touchingOperating Instructions Consumer SupportSupport Ge.comSafety Instructions Troubleshooting Tips Consumer SupportAbout the dishwasher control panel Time Remaining Display on some modelsPlastics Cycle Heavy 6.7 gal., 115 min EnhancementsNormal Wash Heavy 7.8 gal., 75 min Start SelectedPDW8700 Series and PDW8800 Series PDW9200 Series and PDW9800 SeriesClean Status Indicator Lights What It MeansFlashing display lights Recommended dishwasher productsUsing the dishwasher Check the Water TemperatureUse Jet-Dry or Cascade Crystal Clear Rinse Agent Dish Preparation Prior to LoadingProper Use of Detergent InstructionsMain Washer Dispenser NumberSafety Adjustable Upper RackLoading the dishwasher racks Upper RackSafety Lower RackSilverware Basket Removing the Upper RackLoading place settings… Extra Rack Features on some modelsCaring for the dishwasher Before you call for service… Safety Instructions Operating InstructionsError Messages Possible Causes What To Do Problem Possible Causes What To DoCycle that will get them clean This could be etching. Lower the water heater temperatureTouch the START/RESET pad again. Repeat if necessary Make sure inlet water temperature is at least 120FGo off when you’re Setting controls Water standingControl panel lights Water won’t pumpWe’ll Cover Any Appliance. Anywhere Anytime GE Service Protection PlusConsumer Product Ownership Registration Page Page Page Page Warrantor General Electric Company. Louisville, KY GE Dishwasher WarrantyFor The Period GE Will Replace Consumer Support Lave-vaisselle Modèle # Série #Instructions de Fonctionnement Conseils de dépannageConsommateur Fonctionnement Instructions deConseils de dépannage Soutien au Le panneau de contrôle du lave-vaisselle Instructions de sécuritéSoutien au consommateur Conseils de dépannage Voyant de temps restant sur certains modèlesConseils de dépannage Soutien au consommateur ChoixOptions Produits de lavage de vaisselle recommandés Voyants lumineux qui clignotentMise en marche PropreUtilisation du lave-vaisselle Vérifiez la température de l’eauPréparation de la vaisselle avant son chargement Avez-vous oublié d’ajouter une assiette?Bonne utilisation du détergent De sécuritéDistributeur principal de lavage InstructionsChargement des paniers de votre lave-vaisselle SécuritéPanier supérieur Panier supérieur ajustableConseils Panier inférieurPanier à argenterie Enlèvement du panier supérieurChargement des paniers du lave-vaisselle Chargement des couverts…Au consommateur Soins de votre lave-vaisselleConseils de Problème Causes possibles Ce qu’il faut faire Avant d’appeler le service de réparations…Causes possibles Ce qu’il faut faire Problème Causes possibles Ne fonctionne pas De la cuve’eau ne sort pas VapeurOwnership Registration Inscription de propriété de produit de consommation Instructions de fonctionnement Fonctionnement Instructions de sécurité Soutien au consommateur Ce qui n’est pas couvert Garantie GE sur les lave-vaissellePour une période de GE remplacera Soutien au consommateur Service de réparations Pièces et accessoiresStudio de conception réaliste Prolongation de garantie