GE 165D4700P381 Control panel lights, Go off when you’re, Setting controls Water standing, Steam

Page 18

Safety Instructions

Operating Instructions

Before you call for service…

Troubleshooting Tips

Problem

Possible Causes

What To Do

Dishwasher won’t run

Fuse is blown or circuit breaker

• Replace fuse or reset circuit breaker. Remove any other appliances from

 

is tripped

the circuit.

 

Power is turned off

• In some installations, the power to the dishwasher is provided through a

 

 

 

wall switch, often located next to the disposer switch. Make sure it is on.

 

 

Control panel is locked

• Unlock control panel. See page 6.

 

Control panel needs to be

• Turn off power to the dishwasher (circuit breaker or wall switch) for

 

rebooted

30 seconds; then turn back on.

Control panel lights

Time too long between

• Each pad must be touched within 5 minutes of the others.

go off when you’re

touching of selected pads

To relight, touch any pad again, or unlock and relatch door.

setting controls

 

 

 

Water standing in

This is normal

• A small amount of clean water around the outlet on the tub

the bottom of the tub

 

 

bottom at the back of the tub keeps the pump seal lubricated.

Water won’t pump

Drain is clogged

• If you have an air gap, clean it. See page 15.

out of the tub

 

 

• If the dishwasher drains into a disposer, run disposer clear.

 

 

 

• Check to see if your kitchen sink is draining well. If not, you

 

 

 

may need a plumber.

Steam

This is normal

• Warm, moist air comes through the vent by the door latch during drying

 

 

 

and when water is being pumped out. This is necessary for drying.

Tips

Sanitized light does not illuminate at the end of the cycle (Anti-Bacteria cycle only)

The door was opened and the

• Do not interrupt the cycle anytime during or after main wash.

cycle was interrupted during

 

or after the main wash portion

 

The incoming water

• Raise the water heater temperature to between 120°F and 140°F.

temperature was too low

 

The cycle is complete and

• This is normal. No action is required.

the door has been open for

 

longer than 60 seconds

 

Troubleshooting

Consumer Support

Noise

Normal operating sounds

• These are all normal. No action is required.

 

Detergent cup opening

 

 

Water entering dishwasher

 

 

The motor stops and starts at

 

 

various times during the cycle

 

 

Drain pump sounds during

 

 

pump out

 

 

Drying fan running for 2–4 hours

 

 

after CLEAN light is illuminated

 

 

(Top Control Panel models only)

 

 

Rattling dishes when the spray

• Make sure dishes are properly loaded. See the Loading the

 

arm rotates

dishwasher racks section.

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Write the model and serial numbers here Model # Serial # You can find them on the tub wall just inside the doorOperating Instructions Troubleshooting TipsReboot Consumer SupportSupport Ge.comTroubleshooting Tips Consumer Support Control SettingsSafety Instructions About the dishwasher control panelLight 6.3 gal., 85 min Heavy 8.8 gal., 105 minMedium 7.5 gal., 95 min EstablishmentsEnhancements StartFront-Control Dishwashers Flashing display lights CleanStatus Indicator Lights What It Means Recommended dishwasher productsUse Jet-Dryor Cascade Crystal Clear Rinse Agent Using the dishwasherCheck the Water Temperature Dish Preparation Prior to LoadingInstructions SafetyManual Detergent Dispenser Filling Manual Detergent DispenserSmartDispenseTM Detergent Dispenser some models SmartDispenseFront controls Determine the Hardness of Your Tap WaterCalibrationofModelsWithouta3-DigitDisplay Top controlsLoading the dishwasher racks Troubleshooting Tips SupportAdjustable Upper Rack Upper RackSilverware Basket SafetyRemoving the Upper Rack Then fill the lower rack and begin your cycleLoading place settings… Extra Rack Features on some modelsCaring for the dishwasher Error Messages Possible Causes What To Do Before you call for service…Safety Instructions Operating Instructions Problem Possible Causes What To DoThis could be etching. Lower the water heater temperature Flatware Make sure water temperature is at least 120FCycle that will get them clean Make sure inlet water temperature is at least 120FControl panel lights Go off when you’reSetting controls Water standing Water won’t pumpGE Dishwasher Warranty For The Period GE Will ReplaceWarrantor General Electric Company. Louisville, KY Consumer Support Lave-vaisselle Instructions de Fonctionnement Conseils de dépannageEn ce sens, voyez les recommandations du fabricant Conseils de dépannage Soutien auAvant de jeter votre vieux lave-vaisselle Instructions de sécurité Le panneau de contrôle du lave-vaisselleRéglage des contrôles Soutien au consommateur Conseils de dépannageConseils de dépannage Soutien au consommateur Programmes de lavage sélectionsEt attente START/RESET mise en marche/remise à zéroOptions Rinse and Hold rinçage et attenteAu consommateur Produits de lavage de vaisselle recommandésVoyants lumineux qui clignotent Mise en marchePréparation de la vaisselle avant son chargement Utilisation du lave-vaisselleVérifiez la température de l’eau Vous avez oublié de la vaisselle?De dépannage Soutien au consommateur Distributeur manuel de détergentDe sécurité Remplissage du distributeur manuelDistributeur de détergent SmartDispenseMD certains modèles Prenez soin de ne pas mélanger un détergentUn distributeur plein dure environ 1 mois d’usage normal Trouvez la dureté de votre eau d’alimentation Commandes sur le hautInstructions Après avoir réglé la dureté de l’eau, appuyez surPanier supérieur Chargement des paniers de votre lave-vaisselleSécurité Panier supérieur ajustableConsommateur Enlèvement du panier supérieurPanier à argenterie Chargement des paniers du lave-vaisselle Chargement des couverts…Soins de votre lave-vaisselle SoutienAvant d’appeler le service de réparations… Causes possibles Ce qu’il faut faireProblème Causes possibles Ce qu’il faut faire Dans les réservoirs Voile sur les verresDétergent qui reste Du distributeur Eau dans leNe fonctionne pas EnréglantlescommandesLe lave-vaisselle De la cuvePour une période de GE remplacera Garantie GE sur les lave-vaisselleInstructions de sécurité Fonctionnement Ce qui n’est pas couvertStudio de conception réaliste Soutien au consommateur Service de réparationsPièces et accessoires Prolongation de garantie

165D4700P381 specifications

The GE 165D4700P381 is a notable component in the field of electrical engineering, primarily recognized for its application in various industries that require reliable and efficient electrical power management. This product serves as a key element in power distribution systems, ensuring stable performance and effective load management.

One of the main features of the GE 165D4700P381 is its robust design. Engineered to withstand harsh environmental conditions, this device is built with high-quality materials that offer durability and longevity. It is suited for both indoor and outdoor applications, making it a versatile solution for different settings.

The technology embedded within the GE 165D4700P381 reflects the latest advancements in power management systems. It is designed to operate efficiently in a range of temperatures and humidity levels, ensuring optimal functionality regardless of the surrounding environment. This adaptability is critical for industries that face fluctuating conditions, allowing for uninterrupted service.

The GE 165D4700P381 also features integrated protective mechanisms that enhance its safety. With built-in fault detection and prevention systems, it minimizes the risk of electrical failures, thereby protecting connected devices and reducing maintenance costs. These safety features are crucial for applications in sectors such as manufacturing, utilities, and telecommunications, where system reliability is paramount.

Additionally, the GE 165D4700P381 is equipped with advanced connectivity options. This enables seamless integration with smart grid technologies and IoT devices, facilitating real-time monitoring and management of electrical power systems. The ability to connect with digital infrastructure supports enhanced data analytics, allowing businesses to optimize their energy consumption and improve operational efficiency.

Overall, the GE 165D4700P381 stands out as a dependable solution for those seeking to enhance their power management capabilities. Its combination of robust construction, advanced technology, and safety features makes it an ideal choice for various industrial applications. As energy demands grow and systems evolve, the GE 165D4700P381 continues to play a vital role in ensuring reliable electrical performance across multiple platforms.
Top Page Image Contents