4.Check connection by pulling on the copper tubing.
5.Fasten the plastic water line to the refrigerator with a “P” clamp. Slide the plastic water line into the retainer.
A
B
C
A. Brass nut | C. “P” clamp |
B. Compression sleeve |
|
6.Turn on water supply to refrigerator and check for leaks. Correct any leaks.
Style 2
1.Remove plastic cap from water valve inlet port. Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Tighten the compression nut. Do not overtighten. Confirm copper tubing is secure by pulling on the tubing.
2.Create a service loop with the copper tubing. Avoid kinks when coiling the tubing. Fasten the copper tubing to the refrigerator cabinet with a “P” clamp.
A
B
C
D
A. Copper tubing | C. Compression nut |
B. “P” clamp | D. Compression sleeve |
3.Turn on water supply to refrigerator and check for leaks. Correct any leaks.
Complete the Installation
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
1.Plug into a grounded 3 prong outlet.
2.Flush the water system. See “Water and Ice Dispensers.”
Refrigerator Doors and Drawer
All graphics referenced in the following instructions are included later in this section after “Final Steps.”
Remove and Replace Handles
To Remove Handles:
1.Grasp the lower part of the handle firmly, slide the handle up and pull the handle straight out from the door. See Handle graphic.
To Replace Handles:
1.Position the handle so that the large holes in the mounting clips are down and align the holes with the door studs.
2.Rotate the handle so that the mounting clips are flat against the door and slide the handle down to engage. See Handle graphic.
Remove Doors and Hinges
IMPORTANT:
■Remove food and any adjustable door or utility bins from doors.
■Keep the refrigerator doors closed until you are ready to lift them free from the cabinet.
NOTE: Provide additional support for the refrigerator door while the hinges are being removed. Do not depend on the door gasket magnets to hold the door in place while you are working.
TOOLS NEEDED: ⁵⁄₁₆", ³⁄₈", ¹⁄₄" hex head socket wrench, Torx®† T20 screwdriver, #2 Phillips screwdriver, and a
†®TORX is a registered trademark of Textron Innovations Inc.
5