Fisher & Paykel CG902M Temperature control, If the cooktop/hob does not light, Power failure

Temperature control

1Choose the control knob for the burner you want to use.

2Press down and turn the knob anti-clockwise all the way to the high symbol. Hold down the knob for 5 seconds until the burner lights.

All the igniters will spark until the gas ignites on the selected burner.

3The flame can be adjusted anywhere between the high symbol and the low symbol. Do not regulate the flame between high and off.

Flame adjust (Titan knob shown)

If the cooktop/hob does not light

Check that you know how the flame failure device works (refer to page 4).

Check that the power is switched on allowing the electronic ignition to work.

Check the gas is turned on and coming out.

Check that the burner rings are placed correctly.

Clean electrode tips with a toothbrush and methylated spirits.

If the burner has not ignited with 15 seconds, stop operating the igniter and wait at least one minute before attempting a further ignition of the burner.

In the event of the burner flames being accidently extinguished, turn off the burner control and do not attempt to re-ignite the burner for at least 1 minute.

Power failure

In the event of a power failure, the burners can be lit by holding a match close to the side of the burner and turning the control knob to the high flame symbol . Wait until the flame is burning all the way around the burner cap before adjusting.

Heating tips

When you need to boil, simmer or fry your food, first set the temperature to the high flame symbol . Once your pan is boiling, reduce the temperature setting to maintain a steady heat to cook your food through. This will reduce cooking time.

3