Fisher & Paykel OR30SDPWGX manual Installing the Cooktop Front Guard

Page 11

1

INSTALLING THE COOKTOP FRONT GUARD

To increase the clearance between the front edge of the cooktop and the burners it is possible to install the cooktop front guard supplied with the appliance.

IMPORTANT: To install/remove the guard it is necessary to remove the cooktop.

Attempting to install/remove the guard without disassembling the cooktop will result in permanent damage to the appliance.

Install the front guard as shown in figure 1.10:

1.Remove the backguard.

2.Remove the pan supports, the burner caps and flame spreaders.

3.Unscrew cooktop fixing screws (“A” in figure below).

4.Remove the dual burner inner flame spreader (“B” in figure below).

5.Remove the cooktop (keep attention not to damage the gaskets fitted above the burner cups - below the cooktop).

6.Install the front guard “C” by inserting the wire terminals into the proper holes above the control panel (“D” in figure below).

7.Reassemble the cooktop and the other components (steps from 5 to 1).

Pay special attention to the gaskets fitted above the burner cups

A

(below the cooktop); if they are damaged they shall be replaced.

 

A

A

A

 

A

A

 

B

B

 

D

D C

Fig. 1.10

11

Image 11
Contents GAS/ELECTRIC Range What to do if YOU Smell GAS Data Plate Conversion Label Installation Instructions Electrical Grounding Instructions Replacement PartsProximity to Side Cabinets InstallationAssembling the Backguard It is mandatory to install the backguardProximity to Side Cabinets Standard Installation Proximity to Side Cabinets Island Installation Levelling the Range ANTI-TIP Stability Device Installation InstructionsInstalling the Cooktop Front Guard Pressure Regulator Manual Shut-off Valve figPressure Regulator Installation Step GAS Connection Specification Rigid Pipe Connections Leak TestingFlexible Connections Setting the Pressure Regulator Fitting the warming drawer fig To set the pressure regulator figOrifices Table Operations to be Performed When Substituting the OrificesSemirapid burner Setting the Burner MinimumElectrical connection Electric Diagram KEY Wiring DiagramPage Cuisinière À GAZ/ÉLECTRIQUE Mise EN Garde Étiquette DE Conversion Avertissement Instructions D’INSTALLATIONPièces DE Rechange Instructions DE Mise À LA TerreProximité DES Armoires Montage DU Dosseret ’installation du dosseret est obligatoireProximité DES Armoires Installation Standard Proximité DES Armoires Installation EN Îlot Mise À Niveau DE LA Cuisinière Installation DU Dispositif DE Stabilité AntibasculementPage Régulateur de pression Robinet d’arrêt manuel figInstallation DU Régulateur DE Pression Étape Spécification DU Raccordement AU GAZ Vérification de l’absence de fuite Raccords flexiblesRaccords de tuyaux rigides Réglage DU Régulateur DE Pression Pour régler le régulateur de pression fig Installation du tiroir de maintien au chaud figOpérations À Effectuer Pour Remplacer LES Injecteurs Tableau DES InjecteursBrûleur semi-rapide Réglage Minimum DU BrûleurRaccordement électrique Câbles P5B1+P5B2+P5B3 Schéma DE Câblage
Related manuals
Manual 76 pages 28.62 Kb