Thermador PH36HS, PH54GS, PH48HS, PH48GS, PH42GS, PH30HS, PH36GS Wooden Bracket, Hood Size

8.On the wood bracket, mark the locations used to hang the hood according to Figure 8.

Note:

Dashed line indicates cutout needed for clearance of the transition.

The transition supplied with the hood connects to standard 10-inch round duct. Figure 10 shows the transition connected for horizontal discharge.

Screws 2 ea 3” (76 mm)

Wooden

Bracket

A

A

10¼” (260 mm)

Transition

Centerline

HOOD SIZE	A
30” (762 mm)	13” (330 mm)
36” (914 mm)	16” (406 mm)
42” (1067 mm)	19” (483 mm)
48” (1219 mm)	22” (559 mm)
54” (1372 mm)	25” (635 mm)

Figure 8: Hanging the Hood

10½” (267 mm)

Figure 10: Transition Centerline for Horizontal Discharge

Figure 11 shows the hood configured for vertical discharge. Installations using this method require a cutout in the ceiling to accommodate 10" (254 mm) duct and the ½” (13 mm) conduit carrying power to the unit.

9.Drill a 3/16” (4.8 mm) tap hole through the wooden bracket and wall. These 5/8” (16 mm) screws do not need to go into the studs.

10.Use (2) 5/8” (16 mm) screws to secure the wood bracket leaving ¼” (6 mm) of each screw exposed for hanging the hood.

Discharge Direction: Horizontal discharge requires a wall cutout, as shown in Figure 9, to provide clearance for the transition. The location of the cutout is determined by the hood installation height.

5 13/16”

(148 mm)

Transition

Centerline

W

A

L

L

10¼” (260 mm)

Dry Wall

23”(584 mm)

12½” (318 mm)

2¾”(69 mm)	Base of Hood
	Location
	Cooktop Centerline

18” (457 mm)

Figure 11: Transition Centerline for Vertical Discharge

Duct covers, sold separately, are available to cover the space between the top of the hood and ceiling (see Figure 14).

Figure 9: Cutout Dimensions

English 9