Thermador Complete Guide to Installing Ventilation Hoods

11.Remove junction box channel covering the wires.

12.Remove circular knockouts behind junction box channel.

Remove 2 screws

Figure 12: Junction Box Channel

13.Before hanging hood, install transition per Figure 10 or Figure 11. Fasten transition with (2) 3/8” sheet metal screws (supplied) and aluminum tape per all applicable codes.

Note:

Screws must not hinder damper operation.

14.Using two people to lift, rest the hood on the screws in the wood bracket. Use the keyholes labeled "F" in Figure 13. Make sure the wood bracket fits into the recess on the back of the hood.

J

F F

Figure 13: Location of Screw Keyholes

15.Tighten the screws in keyholes. Check hood levelness and adjust if necessary.

16.From inside the hood, drive 5/8” (16 mm) screws through holes in hood into wooden bracket. See holes labeled “J” in Figure 13.

17.Connect additional ducting.

English 10

Duct Covers Assembly & Installation (optional)

Optional duct covers shown in Figure 14 may be used to fill the space between the hood and ceiling in wall mount installations. 6" (152 mm) and 12" (305 mm) high duct covers are available and may be ordered separately (see page 4)

Screw quantity dependent on hood size.

Figure 14: Attachment of Duct Cover(s) to Hood

1.If multiple duct covers are used, connect the pieces together using sheet metal screws provided with the duct cover accessories.

2.Attach the duct cover(s) to the hood using sheet metal screws as shown in Figure 14.

3.From inside of hood, insert 5/8” (16 mm) screws supplied through the holes indicated on each side and along the front, into bottom of the cover.