Thermador PRG48, PRG304, PRDS48, PRG36 installation instructions Typ

Page 8

STEP2: CABINETPREPARATION

GASANDELECTRICSUPPLYZONES:

FIG. 3a

Gas & Electrical Supply Zone for PRG304, PRG36 & PRG48 All-Gas Ranges

Typical placement shown. Other placement of Gas Supply and Electrical Receptacle within the Electrical and Gas Supply Zone is acceptable.

NOTE:

A Manual Gas

Shut-Off Valve (not shown) must be easily accessible through an adjacent cabinet without moving the range.

Three-Prong,

120VAC

Receptacle

2"

16"

1 3/4" Maximum Protrusion from Wall for Gas Supply

5/8" Flex Line to Appliance

Gas & Electrical

Supply Zone

1/2" N.P.T.

5"

The All-Gas Ranges are factory equipped with a power supply cord with a three-prong grounding plug. IT MUST BE PLUGGED INTO A MATING, GROUNDING-TYPE, 120

VAC RECEPTACLE THAT IS CON- NECTED TO A CORRECTLY POLARIZED AND GROUNDED 120 VAC CIRCUIT. (See STEP 6.)

The range must be connected only to the type of gas for which it is certified.

If the range is to be connected to propane gas, ensure that the propane gas supply tank is equipped with its own high pressure regulator in addition to the pressure regulator supplied with the range. (See STEP 5.)

FIG. 3b Gas & Electrical Supply Zone for PRDS304 Dual-Fuel Ranges

Typical placement shown. Other placement of Gas Supply

and Electrical Receptacle within the Electrical and Gas Supply Zone is acceptable.

5/8" Flex Line to Appliance

1/2" N.P.T.

The Dual-Fuel ranges may be connected to the power supply with a 3-pole, 3- conductor range supply cord kit, a 3-pole, 4-conductor range supply cord kit or by hard-wiring to the power supply. It is the

NOTE:

A Manual Gas

Shut-Off Valve (not shown) must be easily accessible through an

adjacent cabinet without moving

the range.

5"

Typ.

 

Both

Sides

2" Maximum Protru- sion from Wall for Gas Supply

240 VAC Receptacle (Shown) or Junction Box

Gas &

Electrical

Supply Zone

20"

4-3/4"

responsibility of the installer to provide the proper wiring components (cord or conduit and wires) and complete the electrical connection as dictated by local codes and ordinances, and/or the National Electric Code. The units must be properly grounded. Refer to Step 6 for details.

The range must be connected only to the type of gas for which it is certified. If the range is to be connected to propane gas, ensure that the propane gas supply tank is equipped with its own high pressure regulator in addition to the pressure regulator supplied with the range. (See STEP 5.)

FIG. 3c Gas & Electrical Supply Zone for PRDS36 and PRDS 48 Dual-Fuel Ranges

Typical placement shown. Other placement of Gas Supply and Electrical Receptacle within the Electrical and Gas

5/8" Flex Line to Appliance

The Dual-Fuel ranges may be connected to the power supply with a 3-pole, 3- conductor range supply cord kit, a 3-pole, 4-conductor range supply cord kit or by

Supply Zone is acceptable.

Gas

Supply

Zone

1/2"

N.P.T.

240 VAC Receptacle

hard-wiring to the power supply. It is the responsibility of the installer to provide the proper wiring components (cord or conduit

NOTE:

A Manual Gas

Shut-Off Valve (not shown) must be easily accessible through an

adjacent cabinet without moving

the range.

8"

Typ.

 

Both

Sides

2" Maximum Protrusion from Wall for Gas Supply

(Shown) or Junction

Box Electrical Supply Zone

A

4"

 

 

B

3-1/4"

 

 

 

and wires) and complete the electrical connection as dictated by local codes and ordinances, and/or the National Electric

Code. The units must be properly

grounded. Refer to Step 6 for details.

The range must be connected only to the type of gas for which it is certified. If the range is to be connected to propane gas, ensure that the propane gas supply tank is

Model

A

B

PRDS36

7"

9"

PRDS48

12"

16"

3-1/2"

equipped with its own high pressure regulator in addition to the pressure regulator supplied with the range. (See STEP 5.)

Page 6

Image 8
Contents Installationinstructionsmanual Professionalranges Importantinstallationinformation Table of Contents IntroductionAvertissementsenfrancais For Residential Use OnlyAvertissement Ventilationrequirements Select Hood and Blower ModelsCabinetpreparation Cabinet ClearancesCabinetpreparation Typ ELECTRICALSUPPLY,DUALFUELRANGES UNPACKING, Moving and Placingthe Range Wires UNPACKING,MOVING and Placingthe RangeINSTALLINGANTI-TIPDEVICE Range Tipping HazardElectrical Shock Hazard Property DamagePRDS304 and PRDS36 Dual Fuel Ranges Figure PRG304 and PRG36 All-Gas Ranges Figures 9, 10, 12a 12b PRDS304 and PRDS36 Dual-Fuel Ranges Figures 11, 14 Prds Wall Mount Gasrequirementsandhookup Hook UPNatural Gas Requirements Propane Gas RequirementsELECTRICALREQUIREMENTS,CONNECTION&GROUNDING Chart C Electrical Supply Circuit RequirementsChart D Power Supply Wire Rating and Size Requirements Location of Junction Box On PRDS304 Range Conductor Securement See . This method is not recommended Do not Ground to a GAS Supply PipeELECTRICALREQUIREMENTS,CONNECTIONS&GROUNDING BackguardinstallationChart D Backguard KIT Model Numbers Testandadjustment StepTo Clean and Protect Exterior Surfaces Griddle GrillInstallerchecklist Final Check ListGAS Supply ElectricalPage
Related manuals
Manual 28 pages 62.99 Kb Manual 120 pages 14.46 Kb Manual 67 pages 43.12 Kb Manual 88 pages 28.71 Kb

PRDS48, PRG304, PRG36, PRG48 specifications

The Thermador PRG30 and PRG36 represent the pinnacle of luxury cooking with their high-performance gas range features and advanced technology. Designed for serious home chefs, these models exemplify efficiency, style, and culinary excellence.

One of the most notable features of the Thermador PRG series is the powerful Pro Grand dual-fuel cooking system. With a combination of gas burners and an electric convection oven, these ranges allow for precision cooking and even heat distribution. The PRG30 boasts a compact size with 30 inches of width, while the PRG36 expands the cooking surface with 36 inches, accommodating larger pots and pans.

Both models come equipped with high BTU burners, reaching up to 18,000 BTUs on the powerful Star Sapphire burners. These allow for rapid boiling and intense heat, ideal for searing meats or achieving high-temperature sautéing. Furthermore, the PRG series includes an innovative simmer setting that enables precise low-heat cooking, perfect for delicate sauces or melting chocolate.

Thermador has integrated their patented Star Burner design in both models. This unique feature provides a larger flame spread compared to traditional round burners. Consequently, it allows for better heat distribution, significantly enhancing cooktop efficiency. The cooktop is designed with six burners, giving chefs the flexibility to cook multiple dishes simultaneously without sacrificing performance.

The ovens in the PRG30 and PRG36 are equally impressive, featuring a spacious capacity of 4.4 cubic feet. The Convection Bake function circulates air for optimal baking results, ensuring even browning and consistent cooking. The models also include a number of innovative cooking modes, such as the Bake, Broil, and Roast settings, enhancing the overall cooking experience.

Additionally, self-cleaning options simplify maintenance, allowing for effortless cleaning after extensive use. The design of the PRG series is complemented by a sleek stainless-steel exterior that not only adds elegance to the kitchen but is also durable and easy to maintain.

In terms of safety, both models feature a safety system that prevents accidental ignition and precise temperature control, ensuring a safe cooking environment. With a focus on high performance, cutting-edge technology, and meticulous design, the Thermador PRG30 and PRG36 gas ranges offer an unparalleled cooking experience for culinary enthusiasts looking to elevate their kitchen capabilities.