GE ZICP720 Level the Refrigerators, Bracket, Place a level inside the machine for each unit

Page 11

Installation Instructions

7

LEVEL THE REFRIGERATORS

• When refrigerators are level, tighten screws against the

bracket.

 

 

Place a level inside the machine for each unit.

Both refrigerators MUST BE LEVEL AND PLUMB with each other and with adjacent cabinetry on each side.

Drawers should be evenly aligned.

Both refrigerators have 4-point leveling. The front is supported by leveling legs, the rear is supported by adjustable wheels. Both are accessible from the front of the refrigerator.

•To level the back of the refrigerator, turn the 7/16″ hex nut located above the front wheels. Turn clockwise to raise or counterclockwise to lower the refrigerator.

•For front leveling, use a 1-1/4″open-end wrench.

•Adjust height of refrigerator to match installation cutout opening 83-1/2″to 84-1/2″. The refrigerator should be level and plumb with cabinetry.

Hex Nut Adjusts

Rear Wheels

Leveling

Leg

Tighten bracket

screws

CAUTION:

The rear leveling wheels and front leveling legs are limited to a maximum height adjustment of 1″. If the installation requires more than 84-1/2″height, the installer should elevate the refrigerator on a sheet of plywood or runners. Cabinetry trim could also be added across the top of the opening to shorten the opening. If you attempt to raise the refrigerator more than 1″, you will damage the front leveling legs and the rear leveling wheels.

PRUDENCE :

Les roues de nivellement arrière et les pattes de nivellement avant permettent un réglage maximal de

25 mm (1 po). Si l’ouverture pour le réfrigérateur a une hauteur supérieure à 2,15 m (84-1/2 po), l’installateur doit élever le réfrigérateur sur une feuille de contre-plaqué ou des glissières. Il est également possible d’ajouter des baguettes de finition des placards sur le haut de l’ouverture afin de

la réduire. Lever le réfrigérateur de plus de 25 mm (1 po) endommage les pattes de nivellement avant et les roues de nivellement arrière.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Installation Instructions Before YOU Begin ContentsInstallation Space Dimensions and Clearances Cabinet door swing. The opening must Frameless Cabinets The case trimOverlaps cabinets at the top and sides Filler strips to prevent interference withDoor Swing optional setting Scale Materials Required Tools RequiredHardware Supplied Trim SuppliedShut off the main water supply Install Water LinesRemove Packaging Skip this step if you are not using side panels Install NEW Side TrimInstall Side Panels Brackets Required Block Install ANTI-TIP BracketsPush Refrigerator Into Opening Receptacles. Reach into the top openingDrawers should be evenly aligned Level the RefrigeratorsBracket Place a level inside the machine for each unitSecure Refrigerator to Cabinetry Alternate ANTI-TIP ProcedureInstall Grille Panel TWO People are Required to Install Grille PanelAdjust Door Swing Install Center Trim StripSkip this Step if Doors are Level Check and Correct Door AlignmentClose the grille panel and both doors RH Fresh Food door is higher than the LH door RH Door Install Dim. a LH Spacer RH SpacerLH Door Install Dim. a LH Spacer RH Spacer Determine Correct SpacerRemove Pin Screws GE SmartConnect Tubing Install Grille Base WrapConnect Water Supply Copper TubingStart Icemaker Connect PowerInstall Toekick Page GE Consumer & Industrial
Top Page Image Contents