GE ZICP720 Install Grille Base Wrap, Connect Water Supply, Copper Tubing, GE SmartConnect Tubing

Page 17

Installation Instructions

14INSTALL GRILLE BASE WRAP

•Open doors fully. Open the grille panel.

•Install the unified double width grille base wrap (E) by slipping the notched ends over the door hinges.

•Install one screw (I) on each end and 2 at the center.

Unified Grille Base Wrap

Place Trim

Over Hinges

15 CONNECT WATER SUPPLY

Connect both refrigerators to the water supply.

•Locate and bring tubing to the front of the cabinet.

•Turn the water on to flush debris from line. Run about a quart of water through tubing into a bucket, then shut off water.

House		Refrigerator
Water Supply		Water Supply

Copper Tubing:

•Slip a 1/4″ nut and ferrule (provided) over both ends of the copper tubing. Insert tube into the union fitting on the unit and tighten nut to union.

•Turn on the water to check for leaks.

GE SmartConnect™ Tubing:

•Insert the molded end of the tubing into the refrigerator connection. Tighten the compression nut until it is just hand tight.

•Tighten one additional turn with a wrench. Overtightening can cause leaks!

•Turn on the water to check for leaks.

NOTE: Make sure excess tubing length does not interfere with drawer closing or toekick installation.

17

Image 17

Contents Installation Instructions Before YOU Begin ContentsInstallation Space Dimensions and Clearances Overlaps cabinets at the top and sides Frameless Cabinets The case trimFiller strips to prevent interference with Cabinet door swing. The opening mustDoor Swing optional setting Scale Hardware Supplied Tools RequiredTrim Supplied Materials RequiredShut off the main water supply Install Water LinesRemove Packaging Skip this step if you are not using side panels Install NEW Side TrimInstall Side Panels Brackets Required Block Install ANTI-TIP BracketsPush Refrigerator Into Opening Receptacles. Reach into the top openingBracket Level the RefrigeratorsPlace a level inside the machine for each unit Drawers should be evenly alignedInstall Grille Panel Alternate ANTI-TIP ProcedureTWO People are Required to Install Grille Panel Secure Refrigerator to CabinetryAdjust Door Swing Install Center Trim StripSkip this Step if Doors are Level Check and Correct Door AlignmentClose the grille panel and both doors LH Door Install Dim. a LH Spacer RH Spacer RH Door Install Dim. a LH Spacer RH SpacerDetermine Correct Spacer RH Fresh Food door is higher than the LH doorRemove Pin Screws Connect Water Supply Install Grille Base WrapCopper Tubing GE SmartConnect TubingStart Icemaker Connect PowerInstall Toekick Page GE Consumer & Industrial