GE ZICP720 installation instructions Installation Space Dimensions and Clearances

5″ Minimum to Wall

Design Guide

THE INSTALLATION SPACE

DIMENSIONS AND CLEARANCES

The installation space must be 71-1/2″.

71-1/2″Finished Width

2-5/16

″

Electrical

24-3/16″

Wall View

6″

6″

10

″

″

″

Cutout Depth

10

75″ From

84-1/2″max

24

Finished Floor

83-1/2″min

3-1/2″

3-1/2″

3-1/2″

3-1/2″

to Bottom of

Finished

Electrical Area

55"″

55"″

55"″

55"″

Opening

10″

10″

3-1/2″

10″

3-1/2″

Water Supply

Water And Electrical Locations

Electrical and water supply must be located as shown.

71-1/2″CaseWidth

83-1/2″at Rear

28-11/16″

DepthIncluding

Handles

25-3/4″CaseDepth

*Shipping height. The

refrigerators can be

adjusted to fit into a cutout that is 83-1/2″ min.to 84-1/2″max.

84″ Notethat thetopcase trim at thefrontis 1/2″ higher andwill overlap

uppercabinetry or

soffit.Useleveling legs

and wheels for a maximum 1″ height

adjustment.

72″Frame to Frame Width

The cutout depth must be 24″

The refrigerator will project forward, slightly beyond adjacent cabinetry, depending on your installation.

Cutout depth beneath a soffit:

When installed beneath a soffit, the soffit cannot exceed the 24″ installation depth shown. The top case trim overlaps the bottom of the soffit.

Additional Specifications

•A separate 115 volt 60Hz., 15 or 20 amp power supply is recommended for each product. An individual properly grounded branch circuit or circuit breaker is recommended. Install properly grounded 3-prong electrical receptacles recessed into the back wall. Electrical must be located on rear wall as shown.

NOTE: GFI (ground fault interrupter) is not recommended.

•Both water lines can enter the opening through

the floor or back wall. Route GE SmartConnect™ kit or 1/4″ O.D. copper tubing between the cold water line and the water connection location.

The tubing should be long enough to extend to the front of the refrigerator. Installation of an easily accessible shut-off valve in the water line is required.

Product Clearances

These refrigerators are equipped with a 2-position door stop. The factory set 130° door swing can be adjusted to 90° if clearance to adjacent cabinets or walls is restricted.

			0″
25″					25″
Min.	to	130° Door		130° Door	Min.	to
Wall		Swing		Swing	Wall

Allow 25″ minimum clearance for a full 130° door swing. Allow 15″ for pan removal.

5″ minimum clearance is required when door swing is adjusted to 90°. If the 90° door stop position is used, pan access is maintained, but pan removal

is restricted.
	90° Door	23	-7/8″
See illustrations on pages
	Swing		Behind
4 and 5 to determine door
			Frame
swing interaction with
adjacent cabinets or
countertops.				″
		36-3/4
	90°

3