GE ZICP720 installation instructions Door Swing optional setting Scale

Page 5

Design Guide

Refrigerator

Case Trim

Frameless Cabinets: The case trim overlaps cabinets at the top and sides. Therefore, frameless cabinets may require filler strips to prevent interference with cabinet door swing. The opening must allow for filler strips.

Door

Top View

90° DOOR SWING (optional setting) Scale 1:1

23-7/8" From Rear of Refrigerator

1/4"

1/2"

3/4"

1-1/4"

1-1/2"

Stainless Steel

	1/4"	3/4" Overlay
	1/4"	Panel
		Panel
		(Nominal Size)
		1/2"

3/4"

1-1/4"

Image 5

Contents Installation Instructions Before YOU Begin ContentsInstallation Space Dimensions and Clearances Overlaps cabinets at the top and sides Frameless Cabinets The case trimFiller strips to prevent interference with Cabinet door swing. The opening mustDoor Swing optional setting Scale Hardware Supplied Tools RequiredTrim Supplied Materials RequiredShut off the main water supply Install Water LinesRemove Packaging Skip this step if you are not using side panels Install NEW Side TrimInstall Side Panels Brackets Required Block Install ANTI-TIP BracketsPush Refrigerator Into Opening Receptacles. Reach into the top openingBracket Level the RefrigeratorsPlace a level inside the machine for each unit Drawers should be evenly alignedInstall Grille Panel Alternate ANTI-TIP ProcedureTWO People are Required to Install Grille Panel Secure Refrigerator to CabinetryAdjust Door Swing Install Center Trim StripSkip this Step if Doors are Level Check and Correct Door AlignmentClose the grille panel and both doors LH Door Install Dim. a LH Spacer RH Spacer RH Door Install Dim. a LH Spacer RH SpacerDetermine Correct Spacer RH Fresh Food door is higher than the LH doorRemove Pin Screws Connect Water Supply Install Grille Base WrapCopper Tubing GE SmartConnect TubingStart Icemaker Connect PowerInstall Toekick Page GE Consumer & Industrial