setting up your side-by-side refrigerator
SETTING UP THE REFRIGERATOR
Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.
If not, first check the power supply and electricity source or try the troubleshooting section at the back of this user’s guide. If you have any further questions, contact your Samsung Electronics service center.
1.Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the Refrigerator. Refer to installation instructions in this manual.
2.Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3.Set the Temperature control [Refer to ‘Freezer/Fridge(Temperature adjustment)’, page 23] to the coldest temperature and wait for an hour. The Freezer will get slightly chilled and the motor will run smoothly.
4.After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can store food and drinks in the Refrigerator after the temperature is sufficiently cool.
5.Assemble the water line to the refrigerator and verify that the couplers are correctly assembled without water leakage. (Refer to ‘Installing the water line’, page 20)
Check the accessory list below.
Hex wrench | Compression fitting Compression nut Clip fitting lock(red) |
Installing the handles
1.Take the handles out from the right side door.
The handles are included in the package.
2.Check if the word “UP” on the rear of the handle is facing right side up.
12_ setting up