Removing residual matter inside the water supply line after installing filter
1. | Turn ON the main water supply. |
|
|
2. | Press the Water button and push the dispenser pad. |
|
|
3. | Refer to ‘Checking the control panel’ in the manual (page 22) | Ice | Water |
Flush 3 gallons of water through the filter befor use. |
|
| |
| (Flush approximately 6 minutes.) |
|
|
| This will clean the water supply system and remove air from the lines. |
|
|
4. Additional flushing may be required in some households.
5.Open the refrigerator door and make sure there are no water leaks coming from the water filter.
A newly installed water filter cartridge may cause water to briefly spurt from the water dispenser. This is due to air getting into the line. It should pose no problem to operation.
01 SETTING UP
Check the amount of water supplied to the ice tray.
1. Lift up the icemaker cover and gently pull it out.
2. When you press the Test button for 3 seconds, the ice cube container is filled with water from the water supply tap. Check to make sure the amount of water is correct(see the illustration below).
If the water level is too low, the ice cubes will be small. This is a water pressure problem from within the main water pipes, not the refrigerator.
1
Check the water level
Ice maker | 2 |
| |
| Test button |
- It will take a few minutes to reach the amount of water you want.
CAUTION - Do not press the test button continuously when the tray is filled with ice or water. Water may overflow or ice jamming may occur.
-When the bucket is not installed, the ice maker does not work.
-When ICE OFF blinks on the display panel, reinsert the bucket and/or make sure it’s installed properly.